Maxon Surpass User manual

INSTALLATION INSTRUCTIONS
Page 1 of 3 (4/12)
309-1984
Product ships unassembled with the glass and base separate.
1. Peel the backer off the double-sided tape on the bottom of the base.
2. Adhere it to the worksurface after lining up with the back edge.
GLASS PRIVACY SCREEN BASE
DOUBLE-SIDE TAPE
Tools Needed:
1. Electric drill with a Philips head
2. Rubber Mallet
Package includes:
1. Glass screen
2. Screen base
3. 3 wood screws
DESK MOUNTED GLASS PRIVACY SCREEN
Failure to install product as instructed, use of hardware other than that which is provided with the product,
or failure to comply with all instructions can result in personal injury.
WARNING
Surpass®

DESK MOUNTED GLASS PRIVACY SCREEN
Surpass
3. Use a drill and screw the wood screws into the worksurface through the 3 holes in
the screen base as shown. Gaskets may need to be moved aside to access the holes.
Use a pencil or screwdriver to push them out of the way and back after the screws are
installed. Screws must go in from the top as shown.
4. Hold the glass firmly and gently tap into the top slot of the base. There are gaskets
in the base to hold the glass in place. Glass must be pressed down as far as it will go
into the base. You may use a rubber mallet to GENTLY tap the glass into place.
Glass Screen Installed in Base
Page 2 of 3 (4/12)
309-1984

INSTALLATION INSTRUCTIONS
Page 3 of 3 (4/12)
309-1984
DESK MOUNTED FABRIC PRIVACY SCREEN
Failure to install product as instructed, use of hardware other than that which is provided with the product,
or failure to comply with all instructions can result in personal injury.
WARNING
Surpass®
1. PRODUCT COMES FULLY ASSEMBLED.
2. USER MUST PEEL BACKER OFF THE DOUBLE-SIDED TAPE ON THE BASE.
3. LINE UP SCREEN WITH SIDE AND BACK-EDGES OF WORKSURFACE- AND PRESS FIRMLY DOWN
HOLDING THE SIDES OF THE SCREEN ONLY. DO NOT GRAB TOP OF SCREEN.
Fabric Screen Assembled