PARK RIGHT®
DUAL LASER with BUILT-IN LIGHT
Models #37314-CL, #37314-RS, #37314-W-RS
V15-1
Included Parts
1- Dual Garage Laser Park with Mounting Bracket
1- AC Adapter (120V AC input, 4.8V DC output)
3- Screws
2- Double-Stick Tape
1. Find a suitable mounting location close to an electrical
outlet (typically the outlet used to power your garage
door opener). The mounting location should be
inaccessible to children or pets. Detach the mounting
bracket from the main unit. Attach the mounting bracket
to the ceiling or wall as shown with the 3 screws or
double-stick tape. Be sure the bracket is oriented
correctly; if you are mounting it on the ceiling, the arrow
on the mounting bracket graphic below should point
towards the garage door; if you are mounting it on the
wall, the arrow graphic on the mounting bracket should
point towards the ground.
CAUTION: Do NOT use double-stick tape to mount the unit on
a ceiling. Mount securely with screws.
2. The batteries are not required and only serve as a backup
if power is interrupted. They will not last for more than a
few days. To install the backup batteries, remove the
battery compartment door and install 3 AA 1.5V
batteries, matching the correct +/- polarity as shown in
the compartment.
3. Slide the main unit into the mounting bracket as shown.
4. Plug in the AC adapter.
5. Park your cars in the desired positions. Adjust the laser
beams so that they shine on a prominent feature on each
car. Good choices include a spot on the dashboard or
the space between the hood and the windshield.
Remember, you must be able to see the spot from the
driver’s seat while parking the car. Do not allow the laser
beams to reflect off a shiny surface and into your eyes.
6. When you or either of your cars first enters the garage,
the motion detector will turn on both lasers and the
built-in light. This provides light anytime there is
movement so you never have to worry about tripping in
the dark or not being able to see where you are going.
Drive forward until the laser for your vehicle hits your
pre-determined spot indicating you are parked in the
correct position. Both lasers will turn off automatically
after you are parked or you have left the garage.
Troubleshooting
The Garage Laser Park lasers may sometimes appear to stay
on permanently and never turn off. The Garage Laser Park
turns on each time it senses motion. It can be triggered by
any movement in the garage such as a door opening, an
animal moving, or a car entering the garage. As a result, a
homeowner may think that the laser never turns off. In these
cases what is usually happening is that each time the
homeowner looks in the garage, the laser is triggered when
the door is opened. If you believe that the laser is not turning
off, please check it in a way that the motion sensor will not be
triggered.
