MAXSA 40330 User manual

Model 40330
Replacing the Batteries or the
Battery Pack

Introduction
Whether you have one of our newer models with 12 LEDs
and just need to replace the batteries, or you have an older
model with 6 LEDs and need to replace the battery pack,
these instructions will guide you, step-by-step, through the
process.
If you have questions at any time, please don’t hesitate
to contact the MAXSA Innovations office for assistance.
Our phone number is 703-495-0661 and we’re happy
to help!

Step 1: Loosen Faceplate
Remove the circled screws from the nuts. Loosen the screws on the side of the
faceplate. There is one screw on each
side.

Step 2: Open Faceplate
Once the front screws have
been removed and the side
screws have been loosened,
rotate the faceplate forward
and down, exposing the
reflecting tray.

Step 3: Remove Reflective Plate
Pull the reflective plate out of
the light. It should lift right out
and expose the LED board. You
will see two screws holding the
LED board in place (circled in
red). Remove them.
Keep track of the bolts. You
will need to switch one with
one of the bolts later on.

Step 4: Remove the LED Board
Pull the LED board out. Be
careful not to sever the wires
connecting the LED board to
the control board still within
the body.
Once removed, you will see the
stand-off bracket. Remove the
outermost screws of the stand-
off bracket, circled in red.

Step 5: Remove the Bracket
After removing the screws,
remove the bracket. This will
expose the battery pack. You
will see the battery pack is
plugged into the control board.

Step 6: Remove the Battery Pack
Unplug the battery pack and
take it out of the light

Step 7: Remove Cover from Bracket
Go to the bracket removed in
Step 5. There are two nuts and
bolts holding the battery pack
cover to the bracket. Remove
them so the cover is no longer
attached to the bracket.

Step 8: Attach Battery Tray to Bracket
Use the bolt set aside from
Step 3. Place it through the
battery tray, then through the
bracket. Put a nut on the end
of it and tighten it.
Note the orientation of the
pieces, be sure yours matches.
The holes in the bracket do not
exactly match up to the holes
in the battery tray. You only
need to secure one hole, as
shown in the picture.

Step 9: Insert batteries
Insert 3 rechargeable AA batteries
into the battery tray.

Step 10: Reinstall Bracket
Place the bracket back into the
body of the light. Be sure the
plug from the battery tray is on
the same side as the control
circuit board.
Use the two screws previously
removed to attach the bracket
back to the stand-offs in the
body.

Step 11: Plug Tray into Control Board
Take the plug from the battery
tray and plug it into the same
socket on the control board
where the original battery pack
was attached. Be sure the
orientation is correct or it will
not fit.
Once plugged in, press the
ON/OFF button on the outside
of the light. If you installed it
correctly, the LEDs should
activate.
If it does not activate, please
call MAXSA innovations for
further troubleshooting. 703-
495-0661.

Step 12: Replace LED Board
Put the LED Board back in place
on the bracket. Use the
remaining bolt from when you
first removed it, and one the
remaining bolt from Step 7
when you removed the battery
cover from the bracket.

Step 13: Close Light Face
Place the reflective plate back
over the LED board. Rotate the
face of the light upwards so it
closes. Insert and tighten the
screws on the front. Then
tighten the screws on the sides
of the faceplate.