May Wes G4 Instruction Manual

4
2.2
2.3
2.4
1
3
2.1
CASE IH 2200/2400/3200/3400 - NEW HOLLAND 96C/96D/98C/98D/996
G4 STALK STOMPER PARTS LISTING/ASSEMBLY INSTRUCTIONS
NOTES:
1
Item 4 is optional and not included in the kit, please order separately
PAGE 1 OF 2
ITEM # PART # DESCRIPTION QTY
1 01130 PIN, 1/2" X 4" BENT HITCH 1
2.1 42295 STALK STOMPER TORSION ASSY 1
2.2 22726 SHOE, STALK STOMPER 1
2.3 00729 BOLT, 1/2"-13 X 1-1/2" HEX FLANGE 4
2.4 00730 NUT, 1/2"-13 HEX FLANGE 4
3 42353 HEADER BRACKET 1
4 22043 MOUNT BRACKET (OPTIONAL)
120 Eastgate Drive SE
Hutchinson, MN 55350
1-800-788-6483
1-320-587-2322
1-320-587-6112 (Fax)
WWW.MAYWES.COM
Doc #: 10286_A

Gear Box
Rollers
Corn Head Frame
Header Bracket
Stalk Stomper Assy
Factory Hardware
Figure 1
Gear Box
Support Brackets
Figure 2
Figure 3
Deck Plate
Mount Bracket
(Optional)
CASE IH 2200/2400/3200/3400 - NEW HOLLAND 96C/96D/98C/98D/996
STALK STOMPER INSTALLATION
Safety Procedure:
- Park combine on level ground and engage the parking brake.
- Raise the head and lock in the upright position.
- Support all row units that stalk stompers will be installed on to ensure row units remain stationary during
installation.
Installation Procedure:
- Remove the factory gearbox support brackets (Fig. 1). Replace with Header Bracket
(42353) positioning the mount plate as pictured below in Figure 2.
- Note:
If installing stalk stomper on the same row that the deck plate cylinder is attached;
replace the factory mounting bracket with Mount Bracket (22043) which is not included
in the kit, please order separately (Fig. 3).
- Insert the Stalk Stomper Assy (43100) into mating feature in the Header Bracket (42353).
Insert lock pin to secure stomper assy in place.
PAGE 2 OF 2
120 Eastgate Drive SE
Hutchinson, MN 55350
1-800-788-6483
1-320-587-2322
1-320-587-6112 (Fax)
WWW.MAYWES.COM
Doc #: 10286_A