MBRP Off Camber Fabrications 130716 User manual

130716© 12/16 Page 2of 4
2007-2017 Jeep JK Light Bar Kit
NOTE: 2012+ models require installation of a
Vacuum Pump Relocate Kit #132032
1. Remove the factory splash guard by removing the push rivets. All
rivets are reusable so be careful removing them. Refer to Figure 1.
2. Remove the Grill by removing the 6 push rivets across the top the Grill
shell. Keep the rivets, they will be reused. The lower edge of the Grill is
secured by clips. Give the Grill a good pull to release the clips. Unplug
the signal lights and set the Grill aside. Refer to Figure 2.
3. Remove the 2 push rivets from the plastic Filler Panel between the
bumper and the rad saddle using a Phillips screwdriver to remove the core,
and then pull the rivets out. These will be reused. Sometimes the core
will spin without backing out. If this happens, try to pry up on the head of
the rivet with a flat screwdriver while unscrewing the core. This will help
the rivet pinch the threads of the core allowing removal. Once the rivets
are out, slide the panel towards the front of the Jeep, then rotate the rear
edge upwards 90 degrees and lift the panel out. This is tricky but it will
come out. Refer to Figures 3 and 4.
4. Pull the wiring harness clips off the frame horns on both sides.
Refer to Figure 5.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5

130716© 12/16 Page 3of 4
5. Install the Driver Side and Passenger Side Frame Brackets onto the
frame horns by first sliding the 5/16” Panel Nuts onto the Nut Plates.
Insert the plates into the pockets on either side of the frame, the brackets
are installed on the inside of the frame rails. Using the supplied 5/16”
hardware, attach each Frame Bracket by bolting through the factory holes
into the Nut Plates. Snug the bolts for now. Adjustment may be required
later.
Refer to Figures 6 and 7.
6. Pre assemble the Light Bar on the floor as shown. Be sure to place
the Gasket between the Mounting Brackets and the Tube. Install the
Panel Nuts making sure that the threaded portion is towards the outside of
the Jeep. NOTE; If you plan to install lights, it is much easier to pre-wire
the bar at this step.. Refer to Figures 8, 9, and 10.
Figure 6
Figure 7
Figure 8
Figure 9

130716© 12/16 Page 4of 4
7. The outermost pocket on each side of the Filler Panel must be trimmed
for the Mounting Brackets to pass through. Use a Dremel tool or similar
to cut as shown. Install the Filler Panel. Do not install the Rivets yet.
Refer to Figures 11 and 12.
8. Install the Grill. Be sure to reconnect the signal light connectors.
Reinstall the Push rivets removed in the previous step.
9. Install the Light Bar assembly by carefully sliding the Mounting
Brackets through the holes previously trimmed in the Filler Panel. Holding
the Light bar assembly in place, use the supplied 5/16” hardware and
reach up from underneath and bolt the assembly to the Frame Brackets.
Do not tighten yet. Refer to figure 13.
10. Align the bar assembly by shifting the Frame Brackets, Mounting
Brackets as required. Tighten all fasteners, including the 2 ½” bolts
securing the Mounting Brackets to the Tube by using an open end
wrench.
Congratulations! You are finished. Thank you for purchasing an MBRP Inc.Product.
Figure 10
Figure 11
Figure 12
Figure 13