MBRP Off Camber Fabrications 130987 User manual

130987 © 12/16 PAGE 2 OF 2
2007-2017 Jeep JK Windshield Light Bar w
Hoop
1. Install the three Grommets into the wiring holes on the underside
of the Crossbar.
2. Remove the four Torx headed fasteners from the left and right side
windshield brackets. Keep these fasteners, you will reuse them.
Refer to Figure 1.
3. Loosely install the Driver Upright and Passenger Upright to the
Jeep with the previously removed Torx head fasteners. Be sure to
install the Gaskets between the body and the Uprights. Install the
Front Crossbar between the Uprights and secure with the supplied
5/16”x2.5 Bolts, 5/16” Washers, and 5/16” Nyloc Nuts. Be sure the
wiring holes are facing forward. Do not fully tighten yet.
Refer to Figure 2.
4. Install the Light Bar between the Uprights with the supplied
5/16” Hex Bolts, and 5/16” Flat Washers. Do not fully tighten yet.
5. Tighten the eight Torx fasteners starting from the top and working
down. The surface of the Jeep is not flat. The fasteners must be
installed from the top down in order for the mounting brackets to fit
correctly.
Refer to Figure 3.
6. Tighten all remaining fasteners.
7. Install the Tube Caps with a soft faced hammer.
Congratulations! You are finished. We are sure that you will enjoy this
Off Camber Fabrications product by MBRP Inc.
Figure 1
Figure 2
Figure 3