McKesson 146-RTL12031KDR User manual

Transfer Bench
aluminum frame
Provides a total weight bearing capacity of 400 lbs (181 kg).
For use with MFR# 146-RTL12031KDR.
ASSEMBLY INSTRUCTIONS
1. Remove contents from carton.
2. Lay both transfer bench seat sections upside
down on a flat surface.
3. Slide smaller seat section into larger section by
depressing the brass push pins and inserting into
the receptacles. Snap buttons will pop out when
secure (Figure 1).
FIGURE 1
4. Remove black top from 4 leg receptacles.
5. Attach leg with the large suction cup (marked “A”)
by depressing the brass push pin and inserting
into the receptacle with the matching “A”. Repeat
for second leg (Figure 2).
FIGURE 2
6. Attach leg with small rubber tip (marked “B”) by
depressing brass push pin and inserting into the
receptacle with matching “B”. Repeat for second
leg (Figure 3).
FIGURE 3
7. Turn transfer bench right-side-up. Attach armrest by
depressing brass push pins and sliding into the arm
receptacle on the side of the bench. Make sure the arm
arcs outward, not inward (Figure 4).
FIGURE 4

Distributed by McKesson Medical-Surgical Inc.
Richmond, VA 23233
PVN B0518
Made in China
For complete details, please visit
mms.mckesson.com/mckesson-brands.
Technical support, replacement parts and
warranty information? Call 1-866-694-5085.
General product questions? Call 1-800-777-4908
8. To assemble backrest, insert support
tube intobackrest support by
depressing push pin and sliding into
backrest tube. Repeat for second
support tube (Figure 5).
FIGURE 5
9. Insert backrest into base by depressing
push pins and sliding support tubes
through both receptacles.
NOTE: Backrest must go through both sets
of receptacles to become secure (Figure 6).
FIGURE 6
NOTE: Back support is reversible to
accommodate left or right tub entry. You can
also change the seat depth of your transfer
bench by pushing the pins under the seat
and sliding the tubes forward until the pins
lock into place.
8. Place legs with the large suction cups into
bath tub.
ADJUSTING LEG HEIGHT
1. To adjust leg height, remove U-Clip adjustment
hole, set leg to desired height and return U-clip
into adjustment hole. Make sure U-Clip clicks
into place. Repeat for remaining legs.
NOTE: Make sure all legs are set to the same height.
2. To be sure legs are locked into place, push
down or pull up on legs.
ADDITIONAL PRECAUTIONS
1. Inspect all parts for shipping damage
before assembly. If there is shipping
damage - DO NOT USE. Contact
dealer/carrier for further instructions.
2. Make certain that the snap buttons fully
protrude through the same respective
holes of each leg extension. This will
ensure that the leg extensions
are securely locked in position and an
even height is achieved.
3. Ensure ALL screws, nuts and/or bolts
are tightened.
4. Check the rubber tips on the leg
extensions for rips, wear or if they are
missing. Immediately replace any or all
if any of these imperfections exist.
5. All four leg extensions with rubber tips
MUST touch the floor simultaneously at
all times.
6. DO NOT stand on the bench.
NOTE: To maintain the beauty of the original
finish, clean with mild soap and rinse with warm
water. Wipe seat dry after each use.