MELAG Pro-Clas User manual

Removing the door panel
Pro-Class, S-
Class
AS_013-13_EN_ProClass_SClass_v0.docx Rev.: 0 – 13/139 1
Instructions for removing the door panel
Tools required: Torx key TX20, Socket Allen key 3 mm
WARNING
Some components of the power electronics and other components remain live even after the power
switch has been switched off. Remove the mains plug.
1. Remove the semi-circular cover on the door interior
panel by removing both Torx screws (Fig. 1).
2. Remove both Torx screws for fixing the locking slider
on the inside of the door (Fig. 2) and remove the
locking slider from the door exterior. Pay attention to
the spacer plates, which are hanging loose on the
retaining collars (Fig. 3, detail).
Fig.
1
Fig.
2
Fig.
3

Removing the door panel
Pro-Class, S-
Class
AS_013-13_EN_ProClass_SClass_v0.docx Rev.: 0 – 13/1958 2
The door panel is fixed to the door interior by the four
screws.
3. Use the socket Allen key to loosen the upper and
lower hexagon screws slightly and remove the plastic
door panel forwards.
Fig. 5 shows the door without the plastic door panel.
Fig.
4
Fig.
5