METER ATMOS 14 User manual

ATMOS 14
4-IN-1 TEMPERATURE AND RELATIVE HUMIDITY SENSOR
SUPPORT
Have a question or problem? Our support team can help.
We manufacture, test, calibrate, and repair every instrument in house. Our scientists and
technicians use the instruments every day in our product testing lab. No matter what your
question is, we have someone who can help you answer it.
NORTH AMERICA
Email: [e-mail]
Phone: [phone]
EUROPE
Email: [e-mail]
Phone: [phone]

ERROR
OK
TEST
(–)
(+)
(–)
(+)
(–)
(+)
(+)
(–)
(+)
(–)
P1 P2 P3 P4 P5 P6
3. Plug Sensor In and
Congure Logger
Plug the sensor into the data
logger. Use data logger software
to apply appropriate settings to
the sensors plugged into each
data logger port.
1. Check Radiation Shield
Ensure the sensor is securely
installed in the radiation shield.
2. Install on Mounting Pole
Use the radiation shield mounting
bracket and V-bolt to mount the
radiation shield to the mounting
pole at the desired height.
Use a wrench to tighten the bolts,
securing the radiation shield to the
mounting pole.
Installation
ATMOS 14 QUICK START
Preparation
Inspect and verify ATMOS 14 components are intact. Installation will
require a mounting post.
Set up and test the system (sensors and data loggers) in a lab
or ofce. Ensure the data loggers are using up-to-date rmware
andsoftware.
Read the ATMOS 14 User Manual at metergroup.com/atmos14-
support/. All products have a 30-day satisfaction guarantee.
18268-01
1.31.2019
ATTENTION
ATMOS 14 requires the most current software and rmware
versions. Please make updates as necessary.
Em50 rmware version 2.27 or higher
EM60 rmware version 1.12 or higher
ProCheck rmware version 1.69 or higher
ECH2O Utility version 1.83 or higher
ZENTRA Utility version 1.12 or higher (with EM60)
Go to metergroup.com/environment/downloads to nd the current
software or rmware version for the data logger being used.