METHVEN Deva ARMC04 User manual

Ceiling Mounted Shower Arm
ARMC04
Installation Guide
Technical Specification
Operating Pressure
Min:
Max:
Operating Temperature
Hot:
Cold:
0.1 Bar
5.0 Bar
65⁰C
5⁰C
METHVEN UK LIMITED
METHVEN EXPERIENCE CENTRE
3/3A STONE CROSS COURT
YEW TREE WAY
GOLBORNE
WARRINGTON
WA3 3JD
UNITED KINGDOM
INST-ARMC04
18/08/2022
TEL: [phone]
FAX: [phone]
EMAIL: [email protected]
www.methven.com
www.deva-uk.com
Warranty Information
Proof of purchase will be required.
The guarantee does not cover faults or damage caused by incorrect
installation and/or maintenance, ordinary wear and tear, water
composition, etc.
*Please see www.deva-uk.com for full terms and conditions of warranty
Cleaning
Your product has a high-quality finish and should be treated with care
to preserve the visible surfaces. Never use abrasives or abrasive
cleaning agents to clean this product clean regularly with
contamination free warm water and a damp soft cloth. Do not use
products containing chlorine bleach or hydrochloric acid as these can
damage the product.
We have a policy of continuous improvement and reserve the right to
change specifications without notice.
Inlet Connections
1/2” BSP
Features:
•Sleek Contemporary Design
•Brass Construction
•Pair with a round or square
shower head

Installation Instructions
Please read all of the instructions before installation.
General
Methven recommends this product is installed by a competent person
in compliance with all relevant regional regulations.
Remove all packaging and check the components for damage before
starting installation.
This product must not be modified in any way as this will invalidate the
guarantee.
It is the responsibility of the installer to ensure a waterproof seal is
achieved, after installation all connections must be checked for leaks.
All outlets used primarily for personal hygiene shall deliver water at a
safe temperature as per regional regulations.
Congratulations on your purchase of your new Deva by Methven Shower
Arm. Our fitting instructions have been created with you in mind to
provide you with all the information you require and, if you need any
further help, please don't hesitate to contact our customer care team
on 0800 195 1602.
Before commencing installation of the new product, ensure that the system has been
flushed to remove any debris, which could cause damage and invalidate the warranty.
1. Install a ½" male threaded connection at the desired position on the
ceiling.
2. Slide trim ring onto the appropriate end of the arm.
3. Screw the arm onto the ½" connection using plumbers tape (NOT
SUPPLIED) or similar to ensure a reliable seal.
4. Push trim ring into place.
5. Connect the shower head (NOT SUPPLIED) to the shower arm thread
and screw on until the head is secured in position (DO NOT
OVERTIGHTEN)
6. Tilt and rotate the shower head to the desired position.
7. Reinstate the water supply and check for any leaks.