METHVEN Kaha 01-7003 User manual

Methven Australia Pty Ltd
ABN 15 104 813 390
Melbourne, Australia
www.methven.com
www.methven.com
JUNE 2011 MA017003
Kaha Swivel Basin Mixer
01-7003
Use of this product in non-domestic applications voids warranty.
All pipe work must be thoroughly flushed prior to the installation of the mixer.
NEFA inline filters must be installed on both hot and cold supplies.
Do not remove the ceramic cartridge from the mixer when installing.
Damage caused by hydrostatic testing is not covered by our warranty.
IMPORTANT
Please read all of the instructions before installation
Installation Guide
Illustration may not reflect actual product shape.
SPEC 001
Stream shaper
O-ring (remove if fitting
base ring)
Mounting stud
Mounting gasket
Mounting plate
Mounting nut
Flexible inlet hose:
cold
hot
Outlet
Position studs
at right angle
to outlet
The maximum working pressure of the ceramic cartridge is 1000kPa. Do not
hydrostatic test the installation with this mixer installed. Damage to the ceramic
cartridge may occur, voiding our warranty.
“In situ” testing
C
M
Y
CM
MY
CY
CMY
K
01-0011 Kaha Basin Mixer.pdf 1 16/05/11 10:06 AM

We recommend that this product is installed by a licensed plumber.
THE METHVEN GUARANTEE
The warranty statement shall apply to all tapware & showers supplied by Methven
For more information visit www.methven.com
THIS WARRANTY ISSUED BY: Methven Australia Pty Ltd, Melbourne Australia
Technical Specifications Installation
Hose Requirements for mixers
The maximum working pressure of the ceramic cartridge is 1000kPa.
Do not hydrostatic test the installation with this mixer installed. Damage to
the ceramic cartridge may occur.
1. A single 35mm diameter hole is required in the mounting surface. The mounting
surface can be a maximum of 40mm thick.
2. Screw the threaded studs into the base of the mixer. Insert the O ring into
the groove in the bottom of the base ring and fit the base ring to the bottom
of the mixer.
NOTE: Base ring use is optional and should be used when required to ensure a seal
is achieved between the tap and basin. If fitting base ring please remove the o-ring
from the base of the tap body.
3. Insert the flexible hoses through the hole in the mounting surface
(from the underside) and screw them into the base of the mixer.
4. Feed the threaded studs through the hole in the mounting surface.
5. Ensure the 2 threaded studs are located at the rear of the mixer at right angle
to the outlet.
Fit the mounting gasket and mounting plate onto the threaded rods.
6. Tighten the mounting nuts to secure the mixer in place.
7. Connect the flexible hoses to the hot and cold supplies (hot on the left,
cold on the right). It is a condition of our warranty that the filter washers as
supplied be fitted at this connection.
Inlet Connections: All ½" BSP
Operating Pressure: 150kPa - 500kPa
Operating Temperatures: Recommended hot water supply 50°C,
maximum 70°C. AS 3500 requires all hot
water supplies to any sanitary fitting to be
tempered to 50°C.
R35mm Min
20mm
DO NOT CRUSH
HOSE OR SWAGED ENDS
CORRECT
INCORRECT
DO NOT STRETCH OR TWIST HOSES
C
M
Y
CM
MY
CY
CMY
K
01-0011 Kaha Basin Mixer.pdf 1 16/05/11 10:18 AM