METHVEN PROMIX SHOWER MIXER User manual

PROMIX SHOWER MIXER
Installation Guide

Ceramic Cartridge Adjustment
Do not remove the ceramic cartridge from the body assembly while carrying
out the following adjustments. Note, the cartridge is factory set for maximum
temperature
Methven warrants this product against manufacturing defects and that it is suitable for use under the
operating conditions specified in this instruction sheet.
For your warranty please refer to www.methven.com or call Customer Service
New Zealand
0800 804 222
Australia
1300 638 483
USA
1800 975 5409
UK
0800 195 1602
ISSUE G
Technical Specifications
Operating pressure: Min 150kPa, Max 1000kPa.
Recommended 150 to 500kPa. Install a NEFA
PLV if supply pressure exceeds 1000kPa.
Operating Temperature: Recommended 5°C to
65°C. Max 80°C. AS/NZS3500 requires
maximum 55°C to all sanitary fittings.
Connections: All ½” BSP
2.5mm hex key
Mix temperature limit
+
_

1
2
3
4
5
6
Red
Blue
IMPORTANT
Please read all instructions before installing
Avoid restrictive piping, fitting or sharp angled bends
when plumbing the mixer. The maximum working pressure of the ceramic
cartridge in 1000kPa. Do not plug the outlet when hydrostatically testing a new
installation as this may damage the ceramic cartridge.
All pipe work must be thoroughly flushed prior to installation of the mixer. NEFA
inline filters must be installed on both hot and cold supplies to prevent foreign
particles damaging the ceramic cartridge.
Lever
Handle
Faceplate
Support Ring
with Seal
Grub Screw
Trim Ring
Screws
Body Assembly
Faceplate O-ring
Trim ring O-ring
Outlet
Hot
Cold
Min 42 mm Max 68 mm
Distance from mounting
stud to outside face
Hole Cutout
100 mm (4”)
Wall Lining
2.5mm hex key
Drain Hole
Drain Hole
O-Ring
Insert desired size.
Blue on right,
red on left.
Select 2, 4 or
8mm off tree
Remove indicators
Indicator Size