METHVEN MAKU User manual

Issue A436910
MAKU SINK MIXER
INSTALLATION GUIDE
TECHNICAL SPECIFICATIONS
Operating Pressure:
Min 35kPa, Max 1000kPa.
Recommended 35kPa - 500kPa.
Recommended installation of a pressure
limiting valve if supply exceeds 500kPa.
Operating Temperature:
Hot: Max 80°C.
Cold: Min 5°C.
NB: New Zealand Building Code Clause G12 -
Water Supplies specifies all outlets used
primarily for personal hygiene shall deliver
water at a safe temperature.
Inlet Connections:
All ½" BSP.
Methven warrants this product against manufacturing defects and that it is suitable for use
under the operating conditions specified in this instruction sheet.
For your warranty please refer to www.methven.com or call Customer Service
New Zealand
0800 804 222
Australia
1300 638 483
UK
0800 195 1602

IMPORTANT
Please read all of the instructions before installation
This mixer is designed for equal and unequal pressure systems.
All pipework must be thoroughly flushed prior to the installation of the mixer. In-line filters
must be fitted on both hot and cold supplies to prevent foreign particles damaging the
ceramic cartridge.
TIP - Install product on bench before connecting second hose to mixer.
CORRECT
INCORRECT
DO NOT STRETCH OR TWIST HOSES
R35mm Min
20mm
Cold
DO NOT CRUSH
HOSE OR
SWAGED ENDS
Stream shaper
Flexible inlet hose:
cold
hot
Max 40mm
Hot
Ø35mm min
Ø42mm max
Equal Low Pressure and Unequal Pres-
sure Installations
Remove flow restricted (yellow) stream
shaper using cache key.
Replace with un-restricted (white) Slim HC
stream straightner.
O-ring
Base ring
Clamping plate
Mounting nuts
Twin Stud Fixing system
Non Return Nipple