METHVEN Deva Insignia Mini INS2313 User manual

Insignia Mini Mono Basin Mixer
with Press Top Waste
INS2313
Installation Guide
Technical Specification
Operating Pressure
Min:
Max:
Operating Temperature
Hot:
Cold:
0.1 Bar
5.0 Bar
65⁰C
5⁰C
Inlet Connections
1/2” BSP
METHVEN UK LIMITED METHVEN
EXPERIENCE CENTRE 3/3A
STONE CROSS COURT YEW TREE
WAY
GOLBORNE
WARRINGTON
WA3 3JD
UNITED KINGDOM
INST-INS2313-v1
TEL: [phone]
FAX: [phone]
EMAIL: [email protected]
www.methven.com
www.deva-uk.com
Warranty Information
Proof of purchase will be required.
The guarantee does not cover faults or damage caused by incorrect
installation and/or maintenance, ordinary wear and tear, water
composition, etc.
*Please see www.deva-uk.com for full terms and conditions of warranty
Cleaning
Your product has a high-quality finish and should be treated with care
to preserve the visible surfaces. Never use abrasives or abrasive
cleaning agents to clean this product clean regularly with
contamination free warm water and a damp soft cloth. Do not use
products containing chlorine bleach or hydrochloric acid as these can
damage the product.
We have a policy of continuous improvement and reserve the right to
change specifications without notice.
Features
•Suitable for a single hole basin
•Single lever tilt and turn
operation
•Long life 35mm ceramic cartridge
•Water efficient - fitted with a
4lpm flow regulator
•Included press top waste
Line Drawing

Tap Installation Instructions
Please read all of the instructions before installation.
General
Methven recommends this product is installed by a competent person in
compliance with all relevant regional regulations.
After installation all connenctions must be checked for leaks.
All outlets used primarily for personal hygiene shall deliver water at a safe
temperature as per regional regulations.
It is the responsibility of the installer to ensure a waterproof seal is achieved.
Waste Installation Instructions
1) Fit the base ring onto the bottom of the tap body. The raised edge of the base
ring sits inside the lip on the base of the tap with the rubber washer facing the
basin.
2) Insert the fixing bolts into the bottom of the tap, with the slot facing out and
using a flat bladed screw-driver tighten this up.
3) Screw the flexible tails into the bottom of the tap, by hand, until tight. Do not use
PTFE tape, or similar, on the threads.
4) Feed the tails and fixing bolt into the hole in the basin, ensuring that the base
ring and rubber washer are seated correctly and fully covering the hole.
5) From the underside of the basin feed the rubber horseshoe shaped washer over
the fixing bolt followed by the metal one. Place the nut over the fixing bolt and
tighten until the tap is fixed on the basin. Do not overtighten.
6) Connect the hot and cold feeds to the water supply.
7) Reinstate the water supply and test for leaks.
1) Remove the backnut, white plastic washer and smaller of the two rubber
washers. Push the larger of the rubber washers up to the waste flange and
insert into the hole for the waste in the basin. Please note sealant can be used
in addition to, or instead of, the washers depending on the requirements of the
installation or preferences of the installer.
2) On the underside of the basin, feed the smaller rubber washer and white
plastic washer back onto the bottom of the waste tail and using the backnut,
tighten until the waste is secure. As above sealant can also be used.
3) Attach the trap/waste pipework to the bottom of the waste body and test for
leaks.