METHVEN Kiri 01-5436 User manual

Methven Australia Pty Ltd
ABN 15 104 813 390
Melbourne, Australia
www.methven.com
www.methven.com
May 2016 MA015092A IssueB
Kiri Brass Plate Mount Mixer
Use of this product in non-domestic applications voids warranty.
All pipe work must be thoroughly flushed prior to the installation of the mixer.
NEFA inline filters must be installed on both hot and cold supplies.
Do not remove the ceramic cartridge from the mixer when installing.
Damage caused by hydrostatic testing is not covered by our warranty.
IMPORTANT
Please read all of the instructions before installation
Installation Guide
Illustration may not reflect actual product shape.
SPEC 001
BATH 01-5436
BASIN 01-5092
Kiri
Applies to basin
mixers only
“In situ” testing
The maximum working pressure of the ceramiccartridge is 1000kPa. Do not
hydrostatictest the installation with this mixer installed. Damageto the ceramic
cartridge may occur, voiding our warranty.

We recommend that this product is installed by a licensed plumber.
THE METHVEN GUARANTEE
The warranty statement shall apply to all tapware & showers supplied by Methven
For more information visit www.methven.com
THIS WARRANTY ISSUED BY: Methven Australia Pty Ltd, Melbourne Australia
Technical Specifications
Inlet Connections: All 1/2’ BSP
Operating Pressure: 150kPa - 500kPa
Operating Temperatures: Recommended hot water supply 50°C,
maximum 70°C. AS 3500 requires all hot
water supplies to any sanitary fitting to be
tempered to 50°C.
Avoid restrictive piping, fitting or sharp angled bends when plumbing the mixer.
The maximum working pressure of the ceramic cartridge is 1000kPa. Do not
hydrostatic test the installation with this mixer installed. Damage to the ceramic
cartridge may occur.
Note: It is recommended to apply a bead of clear silicon sealant on back of the face plate
before fixing to finished wall surface.
Final fit-off (number 6)
A. Trim brass nipple to length, screw into body with teflon sealing tape.
B. Fit face plate to wall (use sealant) and fix with 2 screws as shown.
C. Fit bush and outlet. Note: Do not turn outlet against face plate to avoid
marking. Tighten with Allen key.
D. Assemble ‘O’ ring, flange and handle.