METHVEN AURAJET HANDSET User manual

www.methven.com
Technical Specifications:
Operating Pressure:
Min: 100kPa/1bar
Max: 500kPa/5bar*
Optimum: 150kPa/1.5bar - 500kPa/5bar
Operating Temperature:
Hot: Max 65°C*
Cold: Min 5°C
Inlet Connections:
½" BSP
* Regional specific regulations apply.
Please refer to your warranty statement at
www.methven.com
AURAJET™ HANDSET
Installation Guide

Methven warrants this product against manufacturing defects and that it is suitable for use
under the general operating conditions specified in this instruction sheet. However, regional
regulations apply and may affect your warranty. Please refer to www.methven.com or call
customer service for full details.
New Zealand
0800 804 222
Australia
1300 638 483
UK
0800 195 1602
Run hot water through shower for 2 minutes before first use.
Never use abrasives or abrasive cleaning agents to clean this product. Clean regularly with
contamination free warm soapy water and a damp soft cloth.
A filter washer should be installed in the hose cone on the water outlet and it should be cleaned
periodically.
If shower performance is compromised by the build-up of lime-scale, soak in limescale remover for
up to 10 minutes. Do not attempt to remove limescale with sharp objects or abrasives. Do not use
products containing chlorine bleach or hydrochloric acid as these can damage the shower. Always
rinse the shower thoroughly after cleaning to remove cleaning products that can damage the shower.
Never insert objects into the spray slot or attempt to remove spray cover as this may cause damage
to shower components.
•
•
•
•
IMPORTANT: Please read all of the instructions before installation.
General:
Methven recommends this product is installed by a licensed plumber in compliance with all
relevant regional regulations.
After installation all connections must be checked for leaks.
All outlets used primarily for personal hygiene shall deliver water at a safe temperature as per
regional regulations.
It is the responsibility of the installer to ensure a waterproof seal is achieved.
NOTE: Some showers may not provide an effective shower when used with gravity fed heated
water systems or where pressures are less than 150kPa/1.5bar at the outlet. Additionally showers
with flow rates of less than 9L/min may not allow the following to function correctly:
- some instantaneous water heaters
- some tempering valves
- some thermostatic mixing valves
Care and Cleaning:
•
 ISSUE C

Clean filter washer
periodically
CARE AND CLEANING:
Never use abrasives or abrasive cleaning agents to
clean this product. Clean regularly with
contamination free warm soapy water and a damp
soft cloth.
439972 ISSUE A
OVAL RAIL

•
•
•
•
•
Wall Boss Housing
Grub Srew
Rail
Slider
Internal Mounting
Bracket and Screw
Wall Boss Screws
grub screw
topside
grub screw
underside
Secure the wall boss housings.
NOTE: Ensure protection pads are
used between wall bosses and tiles.
FLOOR
800mm RAIL 595 – 730mm
1850mm (recommended)
VERTICAL
IF SOAP DISH IS
SUPPLIED:
Slide soap dish
onto the rail.
Fit the internal
mounting brackets
by locating in slot
rotating 90
° as
shown.
Tighten the screws
finger-tight using
Allen key.
1.
2.
Match the
mountings
to wall
bosses and
push into
place
Slide the
rail up or
down to
centralise
brackets.
1.
2.
Remove the rail
and tighten the
tensioning
screws until
they lock.
Relocate the rail
onto wall bosses
and tighten grub
screws top and
bottom.
1.
2. To adjust the slider height
push the button and slide
to desired height.
IF HANDSET, HOSE OR WATER OUTLET ARE SUPPLIED:
Connect hose to water outlet and Methven
handset. Ensure swivelling cone is connected to
the handset.
Non-Swivelling
Cone
Filter Washer
Flat Washer
Methven Handset
(If supplied)
Swivelling
Cone
1. 3.2. 4.
5. 6. 8.7.
Water Outlet
(If supplied)
Soap Dish
(If supplied)
Water Outlet
(If supplied)