METHVEN Kiri K1MSK Instructions for use

Kiri Shower Kit
Installation Instructions
& Maintenance Guide
K1MSK
Technical Specifications:
Operating Pressure:
Min 0.3 bar required
* Regional specific regulations apply.
Please refer to your warranty
statement at www.methven.com
65
180
685
Adustable
Centres
600mm
MAX
Hose
1500

Select location for kit, ensuring no wiring or
pipework in the wall can be damaged, also that
when the slider bracket is positioned at the top of
the rail, the hose is not over extended.
The location should also ensure that during use, the
water flow is directed toward a suitable location, so
as not to cause water damage.
Remove the caps from the end brackets using
a sharp blade, taking care not to damage the
product.
Mark the required position of the end brackets on
the wall (the centre to centre dimension is variable,
max 600mm)
Once marked, drill hole and fit wall plugs.
Using screws provided, fit end brackets in desired
location.
INSTKMSKV
65
180
685
Adustable
Centres
600mm
MAX
Hose
1500

Filter Washer
Once both end brackets have been secured, push empty
rail through end bracket, until end is part way between
end brackets, then install slider, soap dish and hose
retainer.
When rail components have been installed, push the rail
through the second end bracket.
To secure the rail, place the small black rubber stopper
into the threaded hole in the front of the end bracket,
then fit the small brass screw and tighten using a screw
driver, until tight against the rail, do not overtighten, then
fit chrome caps.
Fit hose seals to both ends of shower hose.
Thread the hose through the hole in the hose retainer.
Screw the cone end of the hose to the handset.
Screw the opposite end of the hose to the mixer.
Locate the hose cone into the slide bracket, ensuring that
it is fully inserted.
If the cone is not fully inserted, the handset may fall out
during use.
To adjust the angle of the handset, gently move the
handset just above the slider.
To move the slider, press the button and push or pull
the slider, you must always press the button to move the
slider.

METHVEN UK LIMITED
METHVEN EXPERIENCE CENTRE
3/3A STONE CROSS COURT
YEW TREE WAY
GOLBORNE
WARRINGTON
WA3 3JD
UNITED KINGDOM
TEL: [phone]
FAX: [phone]
E: [email protected]
methven.com
INSTKMSKV
Cleaning:
Your product has a high quality finish and should be treated with care to preserve the
visible surfaces.
Never use abrasives or abrasive cleaning agents to clean this product. Clean regularly
with contamination free warm water and a damp soft cloth. Do not use products
containing chlorine bleach or hydrochloric acid as these can damage the product.
Always rinse the product thoroughly after cleaning to remove cleaning products that can
damage the shower.
Warranty info:
Shower Rail 1 Year
Satinjet®Handset  Year
Proof of purchase will be required.
The guarantee does not cover faults or damage caused by incorrect installation and/or
maintenance, ordinary wear and tear, water composition etc.