METHVEN KIRI MK2 User manual

EKIT09/KR
Technical Specification
METHVEN UK LIMITED
METHVEN EXPERIENCE CENTRE
3/3A STONE CROSS COURT
YEW TREE WAY
GOLBORNE
WARRINGTON
WA3 3JD
UNITED KINGDOM
Warranty Information
Proof of purchase will be required.
The guarantee does not cover faults or damage caused by
incorrect installation and/or maintenance, ordinary wear and
tear, water composition, etc.
*Please see www.methven.com for full terms and conditions of warranty
Cleaning
Your product has a high-quality finish and should be treated
with care to preserve the visible surfaces. Never use abrasives
or abrasive cleaning agents to clean this product clean regularly
with contamination free warm water and a damp soft cloth. Do
not use products containing chlorine bleach or hydrochloric
acid as these can damage the product.
KIRI MK2 CHROME EASY FIT SHOWER
Installation Guide
Operating Pressure
Min:
Max:
Operating Temperature
Hot:
Cold:
0.35 Bar
5.0 Bar
65⁰C
5⁰C
Inlet Connections
1/2” BSP
INST-EKIT06/KR-V1
TEL: [phone]
FAX: [phone]
EMAIL: s[email protected]
www.methven.com
We have a policy of continuous improvement and reserve the right to change
specifications without notice.

Please read all of the instructions
before installation.
General
Installation Instructions
Methven recommends this product
is installed by a competent person in
compliance with all relevant regional
regulations.
After installation all connenctions must
be checked for leaks.
All outlets used primarily for
personal hygiene shall deliver
water at a safe temperature as per
regional regulations.
It is the responsibility of the installer to
ensure a waterproof seal is achieved.
1) Use a 6mm drill bit to drill a hole in the
wall at the desired height, drill a second
hole vertically lower at a recommended
height of 550mm. In certain situations,
the hole may need to be further away to
a maximum of 615mm. Place wall plugs
into hole and push firmly into place. Place
fixing bracket over the wall plugs (1) and
insert screw provided, tighten until secure,
repeat for second fixing bracket. Push
rubber grip into fixing bracket aligning the
grove vertically (2)
2) Assemble the handset slider, soap
dish and hose retainer on to the rail
ensuring button is facing upward. Attach
both rail end assemblies.
3) Ensuring the handset slider button is
facing upwards as shown in the illustration,
adjust the two rail end assemblies to match
the position of the wall brackets and turn
wall covers anticlockwise to the unlock
position.
4) Gently press the rail end assemblies onto
the wall brackets, until the rail ends touch
the wall. Turn both wall covers clockwise
into the locking position, securing the rail.
Adjust handset slider to desired height for
showing.
5) Insert flat washer into the shower
hose before screwing to the handset.
Connect the other end of the shower to
the shower outlet.
Place the handset securely into the
handset slider, and turn shower mixer
into the on position and check for leaks.
Flow Regulation
The handset comes complete with a
flow regulator inserted into the inlet.
*Subject to change, based on the specification