METHVEN Kaha 01-7409 User manual

www.methven.com www.methven.com
Kaha Wall Spout
Bath 01-7409
Basin 01-7430
Illustration may not reflect actual product shape.
Use of this product in non-domestic applications voids warranty.
All pipe work must be thoroughly flushed prior to the installation of the mixer.
NEFA inline filters must be installed on both hot and cold supplies.
Do not remove the ceramic cartridge from the mixer when installing.
Damage caused by hydrostatic testing is not covered by our warranty.
IMPORTANT
Please read all of the instructions before installation
Installation Guide
Illustration may not reflect actual product shape.
Use of this product in non-domestic applications voids warranty.
All pipe work must be thoroughly flushed prior to the installation of the mixer.
NEFA inline filters must be installed on both hot and cold supplies.
Do not remove the ceramic cartridge from the mixer when installing.
Damage caused by hydrostatic testing is not covered by our warranty.
IMPORTANT
Please read all of the instructions before installation
Installation Guide
SPEC 001
Applies to Basin Spout only
Kaha Wall Spout
Bath 01-7409
Basin 01-7430
SPEC 001
Applies to Basin Spout only

THE METHVEN GUARANTEE
The warranty statement shall apply to all tapware & showers supplied by Methven
For more information visit www.methven.com
THIS WARRANTY ISSUED BY: Methven Australia Pty Ltd, Melbourne Australia
We recommend that this product is installed by a licensed plumber.
Methven Australia Pty Ltd
ABN 15 104 813 390
Melbourne, Australia
www.methven.com
THE METHVEN GUARANTEE
The warranty statement shall apply to all tapware & showers supplied by Methven
For more information visit www.methven.com
THIS WARRANTY ISSUED BY: Methven Australia Pty Ltd, Melbourne Australia
We recommend that this product is installed by a licensed plumber.
Methven Australia Pty Ltd
ABN 15 104 813 390
Melbourne, Australia
www.methven.com
Technical Specifications
MAY 2011 MA017409
Technical Specifications
Inlet Connections: All 1/2" BSP
Operating Pressure: 150kPa - 500kPa
Operating Temperatures: Recommended hot water supply 50°C,
maximum 70°C. AS 3500 requires all hot
water supplies to any sanitary fitting to be
tempered to 50°C.
MAY 2011 MA017409
Bath Spout
M5 Grubscrew Inlet Connector
½” BSP
(Not Supplied)
2.5mm Hex Key
NOTE: Maximum hole diameter through wall for ½” BSP tube is 22mm.
Faceplate
Bath Spout
M5 Grubscrew Inlet Connector
½” BSP
(Not Supplied)
2.5mm Hex Key
NOTE: Maximum hole diameter through wall for ½” BSP tube is 22mm.
Faceplate
Inlet Connections: All 1/2" BSP
Operating Pressure: 150kPa - 500kPa
Operating Temperatures: Recommended hot water supply 50°C,
maximum 70°C. AS 3500 requires all hot
water supplies to any sanitary fitting to be
tempered to 50°C.