Metra Electronics 99-1008 User manual

INSTALLATION INSTRUCTIONS FOR PART 99-1008
Small Flat Blade Screwdriver I Phillips Screwdriver
1-800-221-0932 www.metraonline.com
KIT FEATURES
©COPYRIGHT 2004-2007 METRA ELECTRONICS CORPORATION
APPLICATIONS
•2003-2006 Kia Sorento LX
•2004.5-2006 Kia Spectra
•Recessed DIN Head Unit
•ISO Head Unit Provisions with Pocket
A) Radio Housing I B) ISO Brackets I C)Trim Plate
KIT COMPONENTS
TOOLS REQUIRED:
99-1008
A
BC

99-1008
• Dash Disassembly
-2003-2006 Kia Sorento LX ...................................................... 1
-2004.5-2006 Kia Spectra ........................................................ 2
• Kit Assembly
-DIN Head Unit Provision........................................................... 3
-ISO DIN Head Unit Provision...................................................... 3
• Final Assembly ...........................................................................4
• Notes.......................................................................................... 5
TABLE OF CONTENTS

99-1008
1
DASH DISASSEMBLY
Disconnect the negative battery
terminal to prevent an accidental
short circuit.
Open ash tray and unsnap and
remove outside trim panels.
(Figure A)
Tip: Start at the bottom of the trim
panels.
1
2
Remove (8) Phillips screw from the
radio trim panel. Disconnect any
plugs from the trim panel and then
remove panel.
(Figure B)
3
Remove (4) Phillips screw from radio
to remove radio.
(Figure C)
4
A
2003-2006 KIA SORENTO LX
B
C
D
Cut along the scored lines of the
radio housing’s mounting tabs.
(Figure D)
5

2
99-1008
DASH DISASSEMBLY
2004.5- 2006 KIA SPECTRA
Using a flat blade screwdriver as a
pry tool, unsnap and remove the
center dash panel including the cli-
mate controls and vents from around
the radio.
(Figure A)
2
A
Remove (4) phillips screws to
remove radio. (Figure B)
3
B
Disconnect the negative battery
terminal to prevent an accidental
short circuit.
1

3
99-1008
KIT ASSEMBLY
ISO DIN HEAD UNIT PROVISION
1
Mount the ISO Brackets to the head
unit with the screws supplied with
the unit.
2
Slide the head unit into the radio
opening until the side clips
engage.
(Figure A)
3
Snap the Trim plate into the Radio
Housing.
A
DIN HEAD UNIT PROVISION
1
Slide the DIN cage into the Radio
Housing and secure by bending the
metal locking tabs down.
(Figure A)
2
Slide the aftermarket head unit into
the cage and secure.
3
Snap the Trim plate into the Radio Housing.
A

4
99-1008
FINAL ASSEMBLY
A
Locate the factory wiring harness in the
dash. Metra recommends using the proper
mating adapter and making the connections
as shown. (Isolate and individually tape off
the ends of any unused wires to prevent
electrical short circuit)
Re-connect the negative battery terminal and test
the unit for proper operation.
A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
1
2
Reassemble in reverse order of disassembly.
3
B
C
D

5
99-1008
NOTES

1-800-221-0932 www.metraonline.com
©COPYRIGHT 2004-2007 METRA ELECTRONICS CORPORATION Rev. 06-13-07
INST991008