Metra Electronics 99-3103 User manual

KIT COMPONENTS
Shaft
Supports
Equalizer
Brackets
99-3103
INSTALLATION
INSTRUCTIONS
APPLICATIONS
CAR PAGE
SATURN
(All models) 1995-99...............................................1-2
TOOLS REQUIRED
Cutting tool
File
Phillips screwdriver
KIT FEATURES
Shaft and
DIN unit
provisions
Equalizer
provisions
Radio Housing
7
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
8
Re-connect the battery terminal and test the unit for proper operation. Mount the head unit/kit
assembly to the sub-dash with (2) 7mm hex-head screws previously removed in step #1.
6
Mount the climate control panel and equalizer to
the sub-dash with (2) screws previously removed
in step #3.
3
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
rev. 290601

2
1
ALL VEHICLES
Disconnect the negative battery terminal to prevent an accidental short circuit. Remove (2)
pop-clips from the sides of the radio trim bezel. Unclip the radio trim bezel, disconnect the
switch wiring and remove the bezel. Remove (2) 7mm hex-head screws securing the top of
the factory head unit and disconnect the wiring.
2-SHAFT HEAD UNITS: Snap the Shaft Supports into the Radio Housing. Slide the
aftermarket head unit into the kit and secure with shaft nuts. (see Fig. A)
DIN HEAD UNITS: Slide the DIN cage into the kit and secure by bending the metal locking
tabs down. Slide the aftermarket head unit into the cage until secure. (see Fig. B)
Loosely mount the Equalizer Brackets to the sides of the equalizer. (see Fig. A). Using the
Radio Housing as a gauge, slide the equalizer and Housing into the sub-dash, adjust the
Equalizer Brackets to locate the proper installation depth and tighten the screws. (see Fig. B)
1
Fig. B
Fig. B
2
5
Fig. A
Fig. A
3 4
Remove (2) Phillips screws securing the
climate control panel to the sub-dash and
remove the panel. Using a small blade or saw, cut away the
protrubing tabs located between the screw
holes and locating pins on the back of the
panel. These tabs are brittle plastic and
should NOT be cut with snips. (see Fig. A).
Measuring in 9/16" from each side of the
climate controlpanel lip, fileaway a 6
13/16" long by 3/32" deep portion of the
panel lip. (see Fig. B)
6 13/16"
3/32"
Fig. A
Fig. B