Metra Electronics 95-3005 User manual

Metra. The World’s Best Kits.®MetraOnline.com © COPYRIGHT 2018 METRA ELECTRONICS CORPORATION REV. 12/4/18 INST95-3005
INSTALLATION INSTRUCTIONS
95-3005
Attention! Let the vehicle sit with the key
out of the ignition for a few minutes before
removing the factory radio. When testing the
aftermarket equipment, ensure that all factory
equipment is connected before cycling the
key to ignition.
KIT FEATURES
• ISO DDIN radio provision
KIT COMPONENTS
• A) Radio trim panel • B) Radio brackets • C) Cutting template
A B C
Chevrolet Astro/GMC Safari 1995-2005
Visit MetraOnline.com for more detailed information about the product and up-to-date vehicle
specific applications
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver
• Cutting tool • Scribe tool
TABLE OF CONTENTS
Dash Disassembly ..................................................2
Kit Preparation .......................................................2
Kit Assembly ..........................................................3
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: 70-1858
Antenna Adapter: 40-GM10
Pocket: 88-00-3302

1.800.221.0932
|
MetraOnline.com
2
1. Engage the parking brake, then place
the gear selector in the lowest position.
2. Unclip, unplug, and remove the
dashboard trim panel. (Figure A)
3. Depress the tabs securing the radio
and slide the radio out in one motion.
Unplug and remove the radio.
Continue to Kit Preparation
DASH DISASSEMBLY KIT PREPARATION
(Figure A)
1. Place the cut template over the
dashboard trim panel. (Figure A)
2. Using a scribe tool, score the area in the
radio section to be cut. (Figure B)
3. Remove the cut template, then cut the
scored area with a cutting tool.
4. Clip the radio trim panel onto the
dashboard trim panel. (Figure C)
Continue to Kit Assembly
Remove shaded area
(Figure A)
(Figure B)
(Figure C)

REV. 12/4/2018 INST95-3005 3
KIT ASSEMBLY
(Figure A)
1. Secure the radio brackets to the radio
using the screws supplied with the
radio. (Figure A)
2. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or Axxess. Test the radio for proper
operation.
3. Clip the radio assembly into the dash.
4. Reassemble the dash in reverse
order of disassembly to complete the
installation.

KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
®
Metra recommends MECP
certified technicians
Metra. The World’s Best Kits.®MetraOnline.com © COPYRIGHT 2018 METRA ELECTRONICS CORPORATION REV. 12/4/18 INST95-3005
INSTALLATION INSTRUCTIONS
95-3005
If you are having difficulties with the installation
of this product, contact our Tech Support line
either by phone at 1-800-253-TECH, or email at
[e-mail]. Before
doing so, look over the instruction booklet a
second time and ensure that the installation was
performed exactly as the instruction booklet
is stated. Have the vehicle apart and ready to
perform troubleshooting steps before contacting
Metra/Axxess Tech Support.