Metra Electronics 99-9223 User manual

1-800-221-0932 • www.metraonline.com
COPYRIGHT© 2002 METRA ELECTRONICS CORPORATION
KIT COMPONENTS
INSTALLATION INSTRUCTIONS
Volvo S60 / V70 2001-02
VEHICLE APPLICATIONS
•Phillips screw
driver
•T-25 Torx Driver
TOOLS REQUIRED
KIT FEATURES
•DIN Head Unit
Provision with
Pocket
99-9223
Questions?
Call the Help Line
(800)253 TECH
INST 999223
rev. 031002
Housing •

99-9223
TABLE OF CONTENTS
•Dash Disassembly 1
•Kit Assembly
Volvo S60 / V70
•DIN Head Unit Provision with Pocket 2
•Final Assembly
•All Vehicles 4

DASH DISASSEMBLY
1Disconnect the negative
battery terminal to
prevent an accidental
short circuit.
2Unsnap gearshift trim
bezel and slide back.
See figure A
3Remove (2) T-25 Torx
from climate control
assembly, proceed to
unsnap assembly from
radio bottom.
See figure B
4Remove (2) T-25 Torx
from radio bottom in
climate control cavity
to remove radio.
See figure C
99-9223 Volvo S60 / V70
A
B
C
1
4
A) Strip wire ends back
1/2"
B) Twist ends together
C) Solder
D) Tape
A
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adapter and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical
short circuit).
See figure A
1
Re-connect the battery terminal and test
the unit for proper operation.
2
Reassemble dash in the reverse order of
the Dash Disassembly on page 1.
3
FINAL ASSEMBLY
99-9223 Volvo S60 / V70
99-9223
99-9223

3
DIN HEAD UNIT PROVISION WITH POCKET
2
Snap the Radio Housing
into radio bracket and
replace rear support
brackets removed in
step #1.
See figure E
1
99-9223 Volvo S60 / V70
Depress snaps on top and
bottom of pocket to remove
from bracket.
See figure C
3
99-9223
Slide radio bracket off of
radio.
See figure D
4
DIN HEAD UNIT PROVISION WITH POCKET
5
With a Phillips screwdriver,
remove the kit rear support
bracket.
See figure A
Slide the DIN unit
(radio) into the cage
until its secure.
See figure G
99-9223 Volvo S60 / V70
99-9223
A
C
D
E
After removing radio, with a
T-25 Torx driver remove (5)
screws from radio bracket.
See figure B
2Slide the DIN cage into
the radio opening, secure
by bending the metal
locking tabs down.*
See figure F
6
7
BF
G
*Note: Also please refer
to instructions included
with radio