Mi-Light FUT088 User manual

This product adopt world-wide used 2.4GHz frequency, GFSK control method, with
the features of low power consumption, long distance transmitting, strong
anti-interference and fast communication rate. Adopt high-precision touching IC
Touching is more stable and sensitive, can control specified Mi-Light smart light
with color, color temperature, saturation and brightness changing.
Product Features
Model No.: FUT088
RGB+CCT Full Touch Remote Controller
Parameters
Model No.: FUT088
Working Voltage: 3V(AAA Battery*2PCS)
Transmitting Power: 6dBm
Standby Power: 20uA
Working Temperature: -20~60℃
Radio Frequency: 2400-2483.5MHz
Modulation Method: GFSK
Control Distance: 30m
Size: 47*16.5*134mm
47mm
134mm
16.5mm
Static Blue Light
Speed+ /10min Delay OFF
Mode
Dimming Slider
OFF
Indicator light
Color Ring
Static Green Light
Speed- / 60S Delay OFF
ON / Link(Unlink)
Static Red Light
Saturation / CCT Control
White
Products Key Diagram
Slide the brightness slider to adjust the brightness.
Touch the color ring to change colors.
Under white light mode, adjust color temperature;
Under color light mode, change color saturation.
Touch OFF button, turn off the linked device.
Static Green Light.
Static Blue Light.
Static Red Light.
Press the button to get white light.
Touch ON button, turn on the linked device.

Made in China
Attention
1. Remote controller only control specified Mi-Light products; not all Mi-Light series can
work on this remote
controller.
2.
In the using of the remote, if the indicated lamp blinking quickly, pls change the battery
in time.
Pls don’t use poor quality battery to avoid the leaking of battery liquid to
damage the remote controller.
3. Please keep your finger off the touch ring when installing the batteries, to improve
its sensitivity, and use the remote ( 3 seconds later ) after the batteries are installed.
Please reinstall the batteries, if the fouch ring is found low-sensitivity.
4. This 2.4GHz remote control system is precise electronic product; don’t use it in humid,
high temperature,
dust and high voltage environment; Saving it at indoor, dry and no
static electricity environment.
5.
Pls don’t use the remote controller on the wide-range metal or strong electromagnetic
wave area, otherwise,
it will badly affect the controlling distance.
Linking Instructions
If the light not blink slowly, the linking failed, Pls switch off the light
again, and follow the above steps again.
Switch off the light,
after 10 seconds
switch on again
1 2
Power
3The light blink 3 times
slowly means the linking is
done successfully.
Power
When the light on, short press
press " ON " 3 times within 3
seconds
Unlinking Instructions
If the light not blink quickly, the unlink failed, pls switch off the light
again, and follow the above steps to unlink again.
Power
3The light blinking 10 times
quickly, means the unlinking
successfully.
Power
Switch off the light,
after 10 seconds
switch on again
1When the light on, short press
" ON " 5 times within 3
seconds
2
Linking&Unlinking
Remark: The light can be working after linking with the remote controller.
Dynamic mode switching button.
Accelerate the speed under present dynamic mode.
Under static mode, Long press for 2 seconds, the light shine once,
the light will be off after 10 minutes.
Slow the speed under present dynamic mode.
Under static mode, Long press for 2 seconds, the light shine once,
the light will be off after 60 seconds.
Link/Unlink
button
Link/Unlink
button