Mi-Light FUT087 Installation instructions

User Instruction
Model No.: FUT087
Touch Dimming Remote Controller

Touch Dimming Remote Controller is a newly developed
remote controller with elegant and fashionable
appearance. We use high-precision IC, touching is
sensitive and stable. And we adopt 2.4G high frequency
wireless control method with the features of low power
consumption, long distance transmitting, strong
anti-interference and fast communication rate. Working
on all our brightness dimming products.
Product Features
Parameters
Working Voltage: 3V(AAA Battery*2PCS)
Transmitting Power: 6dBm
Standby Power: 10uA
Working Temperature: -20~60℃
Radio Frequency: 2400-2483.5MHz
Modulation Method: GFSK
Control Distance: 30m Φ80mm
17mm

OFF: Short press to turn off the light; Long press to
Night Light Mode.
Dimming slider: Touch adjust 1~100% brightness.
1% Brightness
100% Brightness
Products Key Diagram

Installation
1. Install the remote to the
selected place; Keep the
two screw on the same
level; Install it with arrow up.
3. Press downward and rotate
to the left to fix it.
2. Install battery(AAA
battery*2pcs), then fix it on
the base.
Dismantling: Rotate to
the right, then pluck it
down.

2. Install battery(AAA
battery*2pcs), then fix it on
the base.
Linking Instructions
Unlinking Instructions
Noet: If the light not blink slowly, the linking failed, Pls
switch off the light again, and follow the above steps
again.
Noet: If the light not blink quickly, the unlink failed, pls
switch off the light again, and follow the above steps to
unlink again.
1. Switch off the light, after 10 seconds switch on again.
2. When the light on, short press press " ON " 3 times
within 3 seconds.
3. The light blink 3 times slowly means the linking is
done successfully.
1. Switch off the light, after 10 seconds switch on again.
2. When the light on, short press " ON " 5 times within 3
seconds.
3. The light blinking 10 times quickly, means the
unlinking successfully.
Linking&Unlinking
Remark: The light can be working after linking with the
remote controller.

Made in China
1. Remote controller only control specified Mi-Light
products; not all Mi-Light series can work on this remote
controller.
2.
In the using of the remote, if the indicated lamp blinking
quickly, pls change the battery in time.
Pls don’t use
poor quality battery to avoid the leaking
of battery
liquid to damage the remote controller.
3. Please keep your finger off the touch ring when
installing the batteries, to improve its sensitivity, and
use the remote ( 3 seconds later ) after the batteries
are installed. Please reinstall the batteries, if the fouch
ring is found low-sensitivity.
4.
This 2.4GHz remote control system is precise electronic
product; don’t use it in humid, high temperature, dust
and high voltage environment; Saving it at indoor, dry
and no static electricity environment.
5.
Pls don’t use the remote controller on the wide-range
metal or strong electromagnetic wave area, otherwise, it
will badly affect the controlling distance.
Attention