MICODUS MV901 User manual

MV901 User Manual V1.0
Learn how to set up your new MiCODUS Tracker
Copyright ©2022 MiCODUS | All Rights Reserved
R

2.Specifications
Model
Weight
Dimensions
Backup Battery
Working Time
MV901
63.2g
33mm(L) * 15mm(W) * 88mm(H)
1-2 hours
Device Information
Working Voltage
Working Current
Sleep Current
Battery Capacity
Working Temperature
Working Humidity
Working Frequency
SIM Card
Cellular Antenna
Positioning Type
GPS Antenna
Cold Start
Hot Start
Tracking sensitivity
GPS Channels
Position Accuracy
GPS+BEIDOU+LBS
Built-in
≤32 Seconds
≤1 Second
-162 dBm
64
5-10m
2G GSM 850/900/1800/1900MHz
Normal SIM
Built-in
9-80V DC
4V/Average 45mA
4V/less than 5mA
3.7V 150mAh Li-ion Battery
-20°C - 55°C
10%-85%RH non-condensing
Working Parameters
Cellular Specifications
GNSS Specifications
Compact Size 9-80V Wide
Working Voltage
Waterproof
IP67
Realtime Tracking
On Google Maps
History Route
Plaback
ACC Status
Detection
ACC
Overspeed
Alarm
Engine Start
Alarm Geo-fence Lifetime Free Tracking Platform
Power Disconnect
Alarm
1. Main Features
ON / OFF

3.Wiring diagram

4. Activate Device
LED Event State
Charging
Charger inserted and battery has been fully charged
Charger has not been inserted
Searching for network
POWER LED (RED)
CELL LED
(YELLOW) Network has been registered
Solid
Dark
Dark
Flash every 1 second
Solid
GPS has fixed
GPS is in fixing Flash every 1 second
Device is working but stopped more than 5min
Device has not been turn on
Device ran out of battery
GPS LED (BLUE)
ALL LED
Solid
ALL LED TURN OFF
Install the SIM card via the correct direction as below:
APN,ApnName,User,
Password# SET APN OK APN,orange, orange,orange#
APN,internet#SET APN OKAPN,ApnName#
SMS Command
Format Reply Example Note
If the SIM card has APN user and APN
password, then use this command.
If the SIM card operator doesn't have APN
user and APN password, then please use this
command.
Normal SIM
Note: The APN information is very important, it must 100% correct to match with the sim card of
the tracker, if you configured wrong APN, the tracker also will reply "SET APN ok" but it will
can't get online!
Please get the exact correct APN name from local SIM card provider.Take the tracker to a
good signal place for operation and configure the APN for it as below:

5. Package Content
GPS Main Unit
User Guide
Genuine Packing Box
x 1
x 1
x 1
6. Functions Explanation
b. Vibration Alert:
This vibration alert function just work under stationary
status. How to use this function:
* Enable the device to enter into arm mode by this
sms command: ARM#
* Conifgure the alarm ways by this sms command:
SENALM,A,M#
A=ON/OFF, default: OFF;
M=0/1/2, way of alarming,
0 :GPRS only, 1: SMS+GPRS, 2: GPRS+SMS+phone call, default:1
* Configure SOS numbers for the tracker by this sms command:
SOS,A,1st number,2nd number,3rd number#
3 SOS numbers supports at the most
For example:
SOS,A,12345678910#
SET SOS NUMBER OK
ARM#
SET ARM MODE OK
SENALM,ON,1#
SET VIBRATE ALARM OK
MV901
Please follow with the quick user guide carefully!
a. Engine Start/Flameout Alarm
* First Step:
Configure SOS numbers for
the tracker by this sms command：
SOS,A,1st number, 2nd number,3rd number#.
3 SOS numbers supports at the most.
*Second Step:
Configure the alarm ways via
this SMS command：ACCALM,ON,A#
Alarm ways: A=0/1/2 (0 : Platform only, 1: SMS+Platform,
2: Platorm+SMS+CALL, Default:1)
For example:
SOS,A,12345678910#
SET SOS NUMBER OK
ACCALM,ON,1#
SET WAY OF ALARMING OK
MV901

7. Applications

8. Installation Recomendation
Under front windshield
Around dashboard
Under rear windshield
1
2
3
1
3
4
2
1) The decice should face up to the sky.
2) Metal therma barrier of heating layer of the windshield
affects the signal.
Inside the head light
Under the pedal Inside the front cover
Inside the taillight
component
or plastic

Unable to connect to
tracking platform
Check the APN and settings.
Check whrther the data service of SIM card is enabled.
Check the balance of SIM card.
Tracker shows offline
Check whether external power is still connected.
Check if the vehicle entered netword blind area.
Check the balance of SIM card.
9. Troubleshooting
Type Use
10. Full SMS Commands List
Location drift
In area with poor GNSS signal (tall building around or
basement), drifting may happen.
Check whether vibration happens around to trigger the
accelerator.
Unable to locate
Make sure the top side facing upward without metallic things
shielded.
Make sure it’s not in area with no satellite coverage.
No command reply
Make sure command format is correct.
Vehicle may be in network blind area.
Make sure SIM card is well inserted and has SMS servi.
APN Setting
Server Setting
If set with IP: SERVER,0,IP,Port#
APN,Network name[,name,password]#
If set with Domain Name: SERVER,1,
Domain,Port# SERVER,1,d.micodus.net,7700#
SERVER,0,47.254.77.28,7700#
A=old password, six digitals, digital range: 0-9,
default：000000;
B=new password, six digitals, digital range: 0-9
APN,CMNET# (if no name & Password)
APN,internet,internet,internet# (if with name
& Password)
Check IMEI IMEI#
Restore factory
settings
Restart device
FACTORY#
RESET#
Revise the instruction
password PASSWORD,[A],[B]#
Functions Command Format Explanation

Functions Command Format Explanation
Internet Traffic Switch
Version Inquiry
Parameter Inquiry
Check All Alarms Status
TRAFFIC,ON#
TRAFFIC,OFF#
VERSION#
PARAM#
ALARM#
Status Inquiry STATUS#
BATTERY: XX% (Built-in Battery Power Percent)
NET: CLOSED (No Network) FAILED (Connecting
Network or Failure) SUCCESS(Connected
to Network),
NONE (No GSM Signal)
HIGH / MED / LOW (Signal Strength)
GPS: CLOSED (GPS Module Closed) FIXED,
N(Positioned and satellite number) UNFIX,
0 (Not Positioned yet)
ANGLE: 20 (the data upload angle)
SENSOR: ON/OFF (the status of the shake
sensor)
LEVEL: 3 (the sensitivity of the shake sensor)
STATE: ARM/DISARM (the defense status of
the device)
Alarms Parameters ALARM#
ID: 19172012644 (ID number of device)
STATE: ARM(DISARM)(Defense status of device)
SPEED: ON/OFF(alarm status); 30km/h(alarm value);
0/1/2(alarm way)
SHIFT: ON/OFF(alarm status); 300m(alarm value);
0/1/2(alarm way)
VIBRATE: ON/OFF(alarm status);3(sensitivity level);
0/1/2(alarm way)
ACC: ON/OFF(alarm status); 0/1/2(alarm way) ;
0/1/2(0: ACC ON&OFF, 1: ACC ON; 2: ACC OFF)
(alarm situation) ;
POWER DOWN: ON/OFF(alarm status);2 (alarm way)
NOTE: Alarm Ways: 0/1/2 ( 0 :GPRS only, 1: SMS+
GPRS, 2 : GPRS+SMS+phone call )
Map URL Inquiry
Address Inquiry
Time Zone Setting
URL#
POSITION#
GMT,Time zone orientation,Whole
Time Zone[,Half Time Zone]#
GMT,E,8# (if no half time zone)
GMT,W,9,30# (if has half time zone)
NOTE: Parameter : E / W；0 ~ 12; 0/15/30/45
NOTE: Reply message’s language is determined by
device’s language setting, if get position content
failed, device will reply Google Map location link.
Latitude&Longitude
Inquiry WHERE#

Set The Angle Upload
ANGLEREP,[X][,A][,B]#
ANGLEREP,OFF#
X=ON/OFF, default：ON; A=5～180 degrees,
diversion angle
degree, default：30 degrees；B=2～5 seconds,
detecting time, default：3 seconds,
Functions Command Format Explanation
Mileage Statistics
MILEAGE,[A],[B]# A=ON/OFF, On/Off mileage calculation, default: Off
B=0～999999，Mileage initial value , unit：km ;
default: 0, mileage return to zero
MIELEAGE# Query current mileage
Add SOS Administrator
Number
Delete SOS
Administrator Number
Add Center Number
Delete Center Number
Data Upload Time
Interval
SOS,D,1st number,2nd
number,3rd number#
or SOS,D,1,2,3#
CENTER,A,center number#
CENTER,A,13800138000#
NOTE: Center number is only used for cutting off power &
oil, it can only be set by SOS Administrator when using
this command by SMS.
CENTER,D#
TIMER,T1,T2#
T1 ranges 0/5~18000 or 0(seconds), upload interval
when ACC ON, 0 means no upload, default is 10;
T2 ranges 0/5~18000 (seconds), upload interval
when ACC OFF, default is 10;
SOS,A,1st number,2
nd number,
3rd number#
Directly delete the number:
SOS,D,13800138000#
Delete 1st number:
SOS,D,1#
Delete 2nd number:
SOS,D,2#
Delete the 2nd and 3rd number:
SOS,D,2,3#
Set 3 numbers at a time:
SOS,A,13800138000,1380013800 1,13800138002#
Set the first numberseparately:
SOS,A,13800138000#
Set the second number separately:
SOS,A,,13800138001#
Means to set 3rd number separately:
SOS,A,,,13800138002#
Heartbeat Packet
Upload
Sensor Sensitivity
Arm Manually
HBT,time# HBT,3#
NOTE: Range :1-60min, default 3min.
LEVEL,A#
LEVEL,2#
NOTE: A：Sensitivity Level 1-9
(1-9 is from week to strong vibration)
ARM# Set the device into arm mode

Disarm manually
Overspeed Alarm
Setting
Vibration Alarm
Setting
DISARM#
A=ON/OFF, open or close over speed alarm, default：OFF
B=1～255(km/h), speed limit, default：100(km/h);
C=0/1, way of alarm, 0 : GPRS only,
1: SMS+GPRS, default:1.
SPEED,[A][,B][,C]#
SPEED,OFF#
SENALM,[A][,M]#
A=ON/OFF, default: OFF;
M=0/1/2, way of alarming,
0 :GPRS only, 1: SMS+GPRS,
2 : GPRS+SMS+phone call, default:2
SENALM,OFF#
Set the device out of arm mode
Functions Command Format Explanation
Power Disconnect
Alarm
PWRALM,A,B#
A=ON/OFF, default ON;
B=0/1/2/3, ways of alarming, 0: GPRS only, 1: SMS+GPRS,
2 : GPRS+SMS+phone call,
3：GPRS+ call, default:2；
Close power disconnect alarmPWRALM,OFF#
SHIFT,[A][,B][,M]#
SHIFT,OFF#
Shift Alarm Setting
Example: SHIFT,ON,100,1# ( Means Setting 100 meters
shift alarm range, when the ignition turned off, vehicle’s 100
meters’ shift will trigger the alarm. )
A=ON/OFF; default:ON
B=Shift Distance (Range: 100-9999m)
M=0/1/2; way of alarm, 0 : GPRS only,
1: SMS+GPRS,
2: GPRS+SMS+CALL, default:1
ACCARM,ON,M#
ACCARM,OFF#
Auto Arm By ACC
Arm Time: M=5-1800s, default: 60s
Close auto arm function
ACCALM,ON,A#
ACCALM,OFF#
ACC Status Change
Alarm
Alarm Ways：A=0/1/2; way of alarm, 0 : GPRS only,
1: SMS+GPRS, 2: GPRS+SMS+CALL, default:1
Cancel ACC alarm function

E-mail: [email protected]
Skype: MiCODUS
11. Any Questions?
12. Download the APP
Download on the
APP Store
Download for
Android
Search "MiCODUS" in iOS APP store or Google Play
Store, or just scan the QR code as below to download
MiCODUS APP: