Microsemi M1AFS-EMBEDDED-KIT-2 User manual

© 2015 Microsemi Corporation. All rights reserved.
Fusion Embedded Development Kit
QSG0180 Quickstart Guide
Kit Contents – M1AFS-EMBEDDED-KIT-2
Quantity Description
1 Fusion Embedded Starter Kit board with M1AFS1500-FGG484 Fusion device
1 Low-cost programming stick (LCPS)
2 USB 2.0 A to Mini-B cables
1 5 V power pack and modular plugs for power supply
Ethernet
Interface
Ethernet
LEDs
Interface
Connector
RealView
Header
Push-Button
Switch
Jumpers for
Internal or
External Regulator
Mixed-Signal
Test Pins
Mixed-Signal
Header
Push-Button
Switch
Fusion
FPGA
USB
Interface
SRAM
5 V Wall
Jack
Two I2C
Interfaces
Push-Button
PUB
Push-Button
Reset
Potentiometer
LCPS
Interface
User
LEDs
SPI
Flash

50200180-2/04.15
Fusion Embedded Development Kit Quickstart Card
Software Licensing
Download and install the latest release of Libero®System-on-Chip (SoC) software from the
Microsemi SoC Products Group website and register for your free Gold license. Then, install the
most recent SoftConsole release to program and debug your processor-based application.
Libero SoC releases: http://www.microsemi.com/products/fpga-soc/design-resources/design-
software/libero-soc
SoftConsole releases: http://www.microsemi.com/products/fpga-soc/design-resources/design-
software/softconsole
Documentation Resources
For further kit information, including user's guide, tutorial, and full design examples, refer to the
Fusion Embedded Starter Kit page:
http://www.microsemi.com/products/fpga-soc/design-resources/dev-kits/fusion/fusion-embedded-
development-kit
Technical Support and Contacts
Technical support is available online at: www.microsemi.com/soc/support and by email at:
[email protected].
Microsemi SoC Sales offices, including Representatives and Distributors, are located worldwide. To
find your local representative visit: www.microsemi.com/soc/company/contact