Milkcan Ascot Pillar 790 User manual

Installation onto an existing concrete oor Installation onto ground
1. Place your letterbox in
the chosen location and
mark the mounting hole
with a pencil.
3. Place the letterbox back over the concrete hole just drilled.
To bolt the letterbox to the concrete oor, refer to the
steps below.
1. Dig a hole approximately
45cm x 35cm x 10cm deep.
2. Fill hole with concrete.
You will need to install a small concrete slab that is suitable for your
parcel letterbox to be bolted onto.
3. Use a spirit level to level the
concrete and then leave it to
fully dry.
4. Place your letterbox onto the
concrete slab and mark the
mounting hole with a pencil.
5. Drill a hole (10mm diameter x
70mm deep) into the concrete
slab for the mounting bolt.
2. Drill a hole (10mm diameter x
70mm deep) into the concrete
oor for the mounting bolt.
Ascot Pillar
790
- 10mm Masonry Drill Bit
- Spirit Level
Required
Tools
- Hammer Drill
www.milkcan.com.au
[email protected]
[phone]
56 Northgate Drive,
Thomastown VIC 3043
Choosing a Suitable Location
You will need to install it in a location that is easily accessible to Australia Post and couriers.
6. Place the letterbox back over the concrete hole just drilled. To
bolt the letterbox to the concrete oor, refer to the steps below.
1. Check the nut on the expansion bolt has not been tightened, it needs to be loose.
2. Insert the expansion bolt into the concrete through the hole in the base of the letterbox.
3. Tap the expansion bolt fully down. If you encounter some resistance, you may need
a hammer to tap the bolt further into the concrete.
4. Tighten the nut with the tube spanner provided.
Installation using the expansion bolt
1.0
10cm10cm10cm
35cm
FRONT
40cm

Mail and parcels up to 25 x 30 x 18cm can be delivered via the top parcel chute. The mail and parcels will be placed on a
oating oor within the parcel chute and fall into the bottom retrieval area when the lid is closed. The oating oor folds back
up when the lid is opened to stop anyone from reaching into the bottom retrieval area.
This parcel letterbox is specially designed to allow mail and parcel delivery.
Using your Ascot
1.0