Milkcan Vienna 2 786 User manual

Installation onto an existing concrete oor Installation onto ground
1. Place your letterbox in
the chosen location,
remove the base plug
and mark the mounting
hole with a pencil.
3. Place the letterbox back over the concrete hole just drilled.
To bolt the letterbox to the concrete oor, refer to the
steps below.
1. Dig a hole approximately
30cm x 35cm x 10cm deep.
2. Fill hole with concrete.
You will need to install a small concrete slab that is suitable for your
parcel letterbox to be bolted onto.
3. Use a spirit level to level the
concrete and then leave it to
fully dry.
4. Place your letterbox onto the
concrete slab, remove the
base plug and mark the
mounting hole with a pencil.
5. Drill a hole (10mm diameter x
70mm deep) into the concrete
slab for the mounting bolt.
2. Drill a hole (10mm diameter x
70mm deep) into the concrete
oor for the mounting bolt.
Vienna 2 Pillar
786
Required
- Spirit Level
- Hammer Drill
- 10mm Masonry Drill Bit
Tools
www.milkcan.com.au
[email protected]
[phone]
56 Northgate Drive,
Thomastown VIC 3043
Choosing a Suitable Location
You will need to install it in a location that is easily accessible to Australia Post and couriers.
6. Place the letterbox back over the concrete hole just drilled. To
bolt the letterbox to the concrete oor, refer to the steps below.
1. Check the nut on the expansion bolt has not been tightened, it needs to be loose.
2. Insert the expansion bolt into the concrete through the hole in the base of the letterbox.
3. Tap the expansion bolt fully down. If you encounter some resistance, you may need
a hammer to tap the bolt further into the concrete.
4. Tighten the nut with the tube spanner provided. Ret the base plug.
Installation using the expansion bolt
1.0
10cm10cm10cm
30cm
35cm
FRONTFRONTFRONT

Most courier services have the provision for special delivery instructions to be included with a parcel. When you purchase an
item to be delivered, let the supplier know the instruction for opening the combination lock.
For example, the delivery instruction for your parcel letterbox with the lock code set to 321 could be:
“PLACE IN LETTERBOX. USE CODE 321 TO OPEN”.
This parcel letterbox is specially designed to allow mail and parcel delivery. Parcels up to 19 x 25 x 34cm can be delivered
using the combination lock. The courier simply enters the allocated combination code to unlock the front door. The courier
places the parcel inside, closes the door and re-toggles the combination.
Using your Vienna 2
1.0
Set your desired code (new users – set one dial at a time). Release the reset
button to store your new code. Your new combination code is now set.
3. Using the pin, press and HOLD the reset button down.
1. Set the lock to the unlocked code (the factory default setting is 0-0-0) or your previously set personal combination.
For new users we recommend setting the code one dial at a time until you become familiar with the technique
CAREFUL - DO NOT RELEASE THE RESET BUTTON UNTIL YOU HAVE
SET AND MEMORISED YOUR CODE. IF YOU ACCIDENTALLY RELEASE
THE RESET BUTTON THE LOCK WILL BE SET TO WHATEVER CODE
YOU WERE AT.
THE LOCATION OF THE
RESET MAY DIFFER
DEPENDING ON YOUR
PRODUCT
Resetting the Combination Lock
Handy Hint
Push a pin or small nail into the hole.
- If you feel the spring of the reset button you can proceed with step 3.
2. There is a small hole on the side of the lock which gives access to the reset button.
- If you do not feel the spring of the reset button, rotate the lock (this will be either
fully clockwise or anticlockwise depending on your product) and try again.