Milwaukee MC510 User manual

SPECIFICATIONS: MC510
RANGE ±1000 mV
RESOLUTION 1 mV
ACCURACY (@25°C) ±5 mV
SETPOINT 0 to 600 mV
ALARM active when the measure is
lower/higher than setpoint
depending on user selection
OUTPUT POWER SOCKET active when the measure is
higher/lower than selected setpoint
(5A max) depending on user selection
ORP ELECTRODE MA921B/2 (included)
ENVIRONMENT 0 to 50°C, 95% RH max.
POWER SUPPLY 12 VDC (included)
POWER DRIVERS 2A, 60Hz or 230VAC, 1A, 50Hz
DIMENSIONS 148.5 x 82.5 x 32 mm
WEIGHT 180 g (meter only)
OPTIONAL ACCESSORIES:
MA921B/2 ORP Electrode with BNC connector and 2m cable
M10000B Electrode rinse solution, 20 mL sachet (25 pcs)
MA9015 Electrode storage solution, 220 mL bottle
WARRANTY:
This instrument is warranted from all defects in materials and manufacturing for a period of two
years from the date of purchase. The electrode is warranted for a period of 6 months.
If during this period, the repair or replacement of parts is required, where the damage is not due to
negligence or erroneous operation by the user, please return the parts to either dealer or our office
and the repair will be effected free of charge
Note: We reserve the right to modify the design, construction and appearance of our products
without advance notice.
USER MANUAL
PORTABLE
ORP METER
MODEL: MC510
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - TestEquipmentDepot.com

OPERATION:
•Connect the supplied 12
VDC power adapter to the
meter and to the mains line.
•Connect the ORP electrode
to the BNC socket on the
bottom of the meter.
•Always remove the elec-
trode protective cap before
taking any measurement. If
the electrode has been left
dry, soak the tip (bottom 2.5
cm) in rinse solution
(M10000B) for a few minutes to reactivate it.
•Turn the instrument on by pressing the ON/OFF key.
•Allow the reading to stabilize and the meter will start continuous
monitoring.
•The meter is factory calibrated.
•A blinking alarm will indicate when the measured ORP value is lower or
higher than the setpoint, depending on user selection.
NOTE:
•The power contact is not protected by fuse inside the meter. It is
recommended to protect it outside, against failure.
•WARNING: when the alarm led is blinking, the mains voltage is
present in the output power socket.
SETPOINT:
•The setpoint can be selected by
adjusting the central front knob to the
desired value.
•The selectable range for MC510 is
from 0 to 600 mV.
•The nature of the setpoint can be selected by setting the switch to the
desired position (ABOVE or BELOW).
INSTALLATION PROCEDURE:
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - TestEquipmentDepot.com