Mindray VS-900 User manual

1.
VS-900 Vital Signs Monitor
Quick Guide
© 2013-2016 Shenzhen Mindray Bio-Medical Electronics Co., Ltd. All rights
reserved.
Contents of this guide are subject to change without prior notice.
The Monitor is intended for monitoring physiologic parameters, including SpO2,
PR, NIBP, TEMP and CO2, on adult, pediatric, and neonatal patients in healthcare
facilities by clinical physicians or appropriate medical sta under the direction
of physicians.
WARNING：
The equipment must be connected to a properly installed power outlet with
protective earth contacts only. If the installation does not provide for a protective
earth conductor, disconnect it from the power line and operate it on battery
power, if possible.
Shenzhen Mindray Bio-Medical Electronics Co., Ltd.
Mindray Building, Keji 12th Road South, Hi-tech Industrial Park,
Nanshan, Shenzhen 518057 P.R. China
Website: www.mindray.com
Tel. [phone]
Fax: [phone]
0 4 6 - 0 0 4 9 0 5 - 0 0 ( 3 . 0 )

Monitor Mode: The monitor will automatically enter monitor mode after powers on.
Monitor mode is a common mode for monitoring patient vital signs.
Spot Check Mode: The spot mode is intended for on-spot measurement in a short
period. When spot mode is ON, the message area will display [Spot Check] on the top
of screen.
To enter Spot Check mode, select [Main]→[Maintanence>>]→[User Settings>>]→
Enter required password→Set [Spot Check] to [ON].
Standby Mode: In standby mode, the monitoring for current patient is over, but the
monitor still powers on.
To enter Standby Mode, press the power button. Then a warning pops up. Select [Yes]
to enter Standby mode.
Demo Mode: Demo mode is password protected, and it is used for demonstration
purpose only.
To enter Demo mode, select [Main]→[Maintenance>>]→[Demo>>]→Enter required
password→Select [OK].
VS-900 Vital Signs Monitor Quick Guide
This is a Quick Guide. Refer to VS-900 Operator's Manual (PN:046-004883-00) for details.
Power ON/OFF Switch
Press this key to turn the monitor on.
Press this key to enter/exit Standby mode.
When the monitor is on, press and hold this
key for above 2 seconds to turn the monitor
o.
Alarm Reset Key
Press this key to disable the audio of present
alarms.
Press and hold this key for more than 2
seconds to pause or restore alarms.
NIBP Start/Stop Key
Press to start or stop NIBP measurements.
Admit Patient Key
Press this key to admit a new patient.
Press this key to return to main screen.
Knob
Rotate the knob clockwise or anti-clockwise to
move the cursor.
Press the knob to select one item, such as
accessing a menu or conrming the selection.
Interfaces and Menu
NIBP
SpO
2
Side Connectors and Recorder Rear View
NIBP connector
SpO2connector
Recorder
Start/Stop key
AC power
input
Equipotential
grounding
terminal
Network
connector
Multi-
function
connector
Temp
probe
connector
USB
connector
Operating Modes
Keys and Functions
!
CO2
CO2sample line
Connector
CO2gas outlet