MINOURA LEVEL-170 User manual

Read this instruction manual carefully before use.
Bar
Leg
Connecting
Plate
Link Plate
Clamp Jaw
LEVEL-170 Instruction Manual
Thank you for purchasing the Minoura LEVEL-
170 race stand. You may hang up to 5 bikes by
the saddle nose on the horizontal bar of the
170.
The LEVEL-170 comes standard with a 38.1
mm (diameter) x 1700 mm (length) bar. If you
need a different length, a 22.2 mm bar may be
used. Maximum load for the standard bar is
150 kg.
IMPORTANT NOTE
How To Assemble The Stand
1. Holding the bar in one hand, push the right or left leg of the stand out with your
foot until the jaws come in contact with the bar. Once the jaws have come in contact
with the bar, use your hand to push the LINK PLATE down until the jaws and LINK
PLATE lock securely into place. Repeat the procedure for the other side of the stand.
➡
(Fig. A)
(Fig. B)
!

If you use a 22.2 mm bar, you must move the bolt from its factory D position, over one
notch to the C position (see diagram below).
NOTE: ONLY COMBINATION A-C WILL WORK IF YOU USE A 22.2 mm BAR. MAKE SURE
YOU CONFIGURE THE LEVEL-170 TO THE A-C POSITION. NO OTHER COMBINATION
WILL WORK FOR A 22.2 mm BAR.
(Fig. C)
A B C D
15mm 10mm
2. Before placing any bicycle on the stand, be sure that all legs are touching the
ground.
3. To break the stand down, simply use your knee to kick up on the underside of the
LINK PLATE until the jaws let go of the bar. Repeat on the other side.
Using Your Own Bar
HINT
You can hook a wheel or a bag on the bar if you change the clmaping position of the
bar from the edge to any middle area.
For More Information
MINOURA JAPAN HEAD OFFICE
1197-1 Godo, Anpachi
Gifu 503-2305 JAPAN
phone [phone]
fax [phone]
Email: [email protected]
URL: http://www.minoura.co.jp
MINOURA NORTH AMERICA
37653 B Argyle Rd,
Fremont, CA 94536-4918 U.S.A.
phone [phone]
fax [phone]
Email: [email protected]
MADE IN JAPAN
Copyright © Minoura Co.,Ltd. , 2000