modway Chair EEI-3413 User manual

EEI-3413/ EEI-4327 CHAIR/ LOVESEAT
Customer Service 609-256-9000︱www.modway.com
Page 1of 2
Thank you for purchasing the MODWAY Chair/Loveseat.
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2.Owing to the size and weight of the Chair/ Loveseat, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of children.
Hardware:
Components:
Bolt M8X70mm x8
Flat Washer x8
1. Chair Body x1 2. Front Leg x2 3. Left Back Leg x1 2. Right Back Leg x1
A.
C.
Allen Wrench x1
D.
Spring Washer x8
B.
1
2
3
4
EEI-3413
EEI-4327

EEI-3413/ EEI-4327 CHAIR/ LOVESEAT
Customer Service 609-256-9000︱www.modway.com
Page 2of 2
STEP 1:
1. Please put Chair Body (1) upside down on a carpeted or padded surface.
2. Open the velcro on the bottom of the Chair Body (1) and take out 2 pieces of Front Legs (2), 1 piece of
Left Back Leg (3), 1 piece of Right Back Leg (4) and hardware package.
3. Attach 2 pieces of Front Legs (2) to the front of Chair Body (1) by using 4 pieces of Bolts (A) with 4 pieces
of Spring Washers (B) and 4 pieces of Flat Washers (C) as shown.
4. Attach 1 piece of Left Back Leg (3) to the left back of Chair Body (1) by using 2 pieces of Bolts (A) with 2
pieces of Spring Washers (B) and 2 pieces of Flat Washers (C) as shown.
5. Attach 1 piece of Right Back Leg (4) to the right back of Chair Body (1) by using 2 pieces of Bolts (A) with 2
pieces of Spring Washers (B) and 2 pieces of Flat Washers (C) as shown.
6. Use Allen Wrench (D) to tighten all Bolts (A) clockwise as shown.
Legs + Hardware package Inside
STEP 2:
Close the Velcro on the bottom of the Chair Body (1). Carefully turn over the assembled Chair.
Assembly is complete. Your Chair is ready to enjoy now!