modway EEI-3855 User manual

EEI-3855/3856/3857 BAR STOOL
Customer Service 609-256-9000︱www.modway.com
Page 1of 2
Thank you for purchasing the MODWAY BAR STOOL.
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2.Owing to the size and weight of the Bar Stool, we recommend that it is assembled by two adults, on a carpeted
or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of children.
Hardware:
Components:
Flat Washer M6 x4
1. Stool Body x1 2. Frame x1
B.
Bolt M6x25mm x4
A.
F.
Allen Wrench x1
C.
D.
Spring Washer M6 x4
E.
Screw driver x1
* Not include hardware package
Screw x2

EEI-3855/3856/3857 BAR STOOL
Customer Service 609-256-9000︱www.modway.com
Page 2of 2
STEP 1:
1. Please put Stool Body (1) upside down on a carpeted or padded surface.
2. Attach Stool Body (1) to Frame (2) by using 4 pieces of Bolts (A) with 4 pieces of Spring Washers (B)
and 4 pieces of Flat Washers (C). Tighten all Bolts (A) by using Allen Wrench (D) clockwise
as shown in Figure 1.
3. Insert 2 pieces of Screws (E) into the holes in the Frame (2), Tighten Screws (E) by using Screw driver (F)
clockwise fully as shown in Figure 2. Then fully tighten all Bolts (A) by using Allen Wrench (D).
STEP 2:
Carefully turn over the assembled Bar Stool.
Assembly is complete. Your Bar Stool is ready to enjoy now!