modway EEI-798 User manual

Customer Service 908-368-1025︱
︱︱
︱www.modwayfurniture.com Page 1 of 2
EEI -798 BLACK METAL TWIN BED
Hardware:
Component:
ABolt M6x60mm x4
BNut x4
COpen Wrench x1
DAllen Wrench x1
1Headboard x1 2Footboard x1
3Side Rail with Slats x2 4Support Leg x2
Thank you for purchasing the MODWAY BED！
！！
！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the bed, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approx assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that has been provided.
6.Please keep all fitting out of reach of children.
1
2
3
3
4
4

Customer Service 908-368-1025︱
︱︱
︱www.modwayfurniture.com Page 2 of 2
EEI -798 BLACK METAL TWIN BED
Ax4 Bx4 Dx1 Cx1
STEP 1:
Place the 2pcs Side Rail with Slat (3) into 1pc Support Leg (4) as shown.
Insert 2pcs Bolt (A) into the pre-drilled Holes on the Support Leg (4) through the pre-drilled holes on the Side Rail.
Secure them by using 2pcs Nut (B) from the bottom of the Support Leg (4).
Tighten the Bolt (A) and Nuts (B) with Open Wrench (C) and Allen Wrench (D) as shown.
Repeat the same steps for the remaining Support Leg (4).
Hardware & Tool required
STEP 2:
3
3
4
4
3
3
4
3
3
4
A
A
B
B
C
D
Assembly is completed. The bed is ready to enjoy now!
Place the Headboard (1) close to the assembled Side Rail with Slat (3) and Support Legs (4).
Insert the hooks on the Side Rail with Slats (3) into the hook holder on the Headboard (1) as shown.
Repeat the same steps for the Footboard (2).
3
2
3
4
4
1
1
3Hooks on side rails
Hook Holder on
Headboard/Footboard