modway EEI-2774 User manual

Customer Service 908-368-1025︱ Page 1 of 3
EEI-2774/2775 COFFEE TABLE
Hardware:
Component:
A Bolt M8x35mm x12
1 Table Top x1
Thank you for purchasing the COFFEE TABLE！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the coffee table, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approx assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that has been provided.
6.Please keep all fitting out of reach of children.
2 Table Leg x2
C
4 Bottom Rail x2
Allen Wrench M5 x1
Flat Washer M8 x12
B
1
2
2
3
4
4
3 Top Rail x2
D Screw M4x55mm x16
PHILLIPS HEAD SCREW DRIVER
NOT PROVIDED

Customer Service 908-368-1025︱ Page 2 of 3
EEI-2774/2775 COFFEE TABLE
STEP 1:
Ax12 Bx12 Cx1 Hardware & Tool required
STEP 2:
Please put Table Legs (2)on a carpeted or padded area.
Position Top Rail (3) and Bottom Rail (4) to Table Legs (2) as shown.
Insert 4 pieces of Bolt (A) with 4 pieces of Flat Washer (B) into the pre-drilled holes on Table legs (2) through the pre-drilled
holes on Top Rail(3).
Insert 8 pieces of Bolt (A) with 8 pieces of Flat Washer (B) into the pre-drilled holes on Table Legs (2) through the pre-drilled
holes on Bottom Rail (4).
Use Allen Wrench (C) to tighten Bolt (A) clockwise until secure.
Dx16 PHILLIPS HEAD SCREW DRIVER
NOT PROVIDED Hardware & Tool required
Please put Table Top (1) upside down on a carpeted or padded area.
Position the assembled Table Legs(2), Top Rail (3), Bottom Rail (4) and Support Rails (5) upside down to Table Top (1)
as shown.
Insert 16 pieces of Screw (D) into the pre-drilled holes on Table Top (1) through the pre-drilled holes on Table Leg (2) and
Bottom Rail (4).
Use Phillips Head Screw Driver (Not provided) to tighten all Screw (D) clockwise until secure.
3
A
2
4
B
2
A
D
5
3
4
1
2
D
C
B
A
B
A
B
A
B AB
2
3
4
A
B
A
B
C
3
2
4
3
D D
D
D
D
D
D D
D
D
D
D
D
D
Pre-drilled Holes

Customer Service 908-368-1025︱ Page 3 of 3
EEI-2774/2775 COFFEE TABLE
STEP 3:
Assembly is complete. Your table is ready to be used now!
Carefully turn over the assembled table.