7
www.morphyrichards.com
Assembly
Setting up
1Ensure the appliance is unplugged
from the mains.
2To fit the bowl, align the handle as
shown. Turn the handle clockwise
until it is clicked into place A.
(Note, the handle can be located for
left hand ⁄or right hand ¤use).
3Fit the detachable drive shaft over
the induction motor drive B.
4Select the appropriate blade and fit
over the detachable drive shaft,
referring to ‘fitting and using the
tools’ for details.
5Fit the lid to the processor bowl by
aligning the indicator on the lid to
the right hand side of the handle
and then rotate clockwise, until the
lid clicks firmly into place C.
6Ensure that both food pushers are
in place beforeprocessing. They
should only be removed to insert
food D.
FITTING AND USING THE
TOOLS
In general, all attachments (with the
exception of the mini processor
bowl and small blade) which are
fitted within the processor bowl
must be firmly attached to the
detachable drive shaft. Always
adjust the attachments until you are
sure that they are correctly fitted.
Detachable drive shaft
Insert attachments over the top of
the detachable drive shaft and
ensurethat they aresecurely
clicked into place. Then remove the
blade covers (if applicable), taking
care as the blades are sharp E.
Chopping blade
1Fit the processor bowl as detailed
previously.
2Fit the chopping blade over the
motor drive, and fit firmly into
place F.
Warning: Use extreme caution -
the blades are sharp. Always
handle the chopping blade by its
central plastic section.
3Place the food into the bowl.
4Fit the lid and click into place as
detailed in the ‘Setting up’ section.
5Plug in the processor and switch to
speed 1 G.If the processor does
not come on, check that processor
lid is correctly fitted.
Warning: For safety, always use
the food pusher when putting
food into the feeder tube. Never
feed by hand or utensils.
6For large foods feed through with
the large food pusher. The small
pusher should be locked into place
when using. When processing small
pieces of food, unlock and use the
small food pusher, leaving the large
pusher in place in the lid H.
WARNING: Do not use the small
food pusher without the large
food pusher being in place in
the lid feed tube.
7When the processing is complete,
remove the blade from the bowl
before removing the processed
food.
Dough blade
1Fit the processor bowl into place as
described in ‘Setting up’.
2Place the dough blade on the
detachable drive shaft. Then place
the ingredients in the bowl.
3Fit the lid and slot into place, make
sure that it clicks.
4Now plug in the processor.
5Turnthe processor on and operate
until the dough has formed into a
small ball.
6Remove the blade from the bowl
before removing the dough.
A
⁄¤
C
B
D
E
F
H
G
g
