Tools Needed
• ⁄" Wrench
• ⁄" Wrench
• ⁄" Socket
www.MORryde.com • 574.293.1581
Heavy. Duty. Adventure.
STEP 1
Before the installation of the Overland rack can proceed,
the third brake light needs to be unplugged
• To accomplish this, use a T20 Torx bit and uninstall the 4 screws
from the back side of the spare tire carrier. Once the screws are
removed, unplug the third brake light.
INSTALLATION INSTRUCTIONS
STEP 3
Install new, low-profile stop
bracket in place of the stop
bracket that was just removed.
STEP 4
•
Unbolt tailgate guide arm from
tailgate using T30 socket and
place the provided ¼" spacers
between the tailgate guide arm
bracket and the tailgate.
• Then, bolt the tailgate guide arm
bracket back to the tailgate with
the spacers between the tailgate
and the bracket.
Overland rack
STEP 2
Remove Heavy-Duty Tailgate
Hinge stop bracket using 5/32"
allen wrench.
JK
JP54-035
STEP 5
Remove (2) driver side bolts
from Spare tire Carrier.
• ⁄" Allen Wrench
• ⁄" Socket
• T20 Torx
• T30 Torx
STEP 6
Line-up holes in driver side
support with the bolt holes in
the spare tire carrier and reinstall
using M8-2.5 x 80mm bolts.
NOTE: Don’t tighten bolts down
until assembly is complete.
STEP
7
Fasten driver side Molle grid
bracket to driver side support
using (4) supplied ¼"-20 button
head bolts to bolt through Molle
grid bracket and into rivet nuts
in driver side support.
