www.MORryde.com • 574.293.1581
Heavy. Duty. Adventure.
JP54-063
INSTALLATION INSTRUCTIONS
JLU Side mount
JL
STEP 9
Looking at the pinch seam
below the Jeep, line up the
bottom-most slots in the side
mount with the front-most
holes in the pinch seam on
the Jeep.
STEP 8
Install the provided M8-1.25 bolts through the side mount
and into the windshield bracket with the appropriate spacers
between the side mount and the Jeep. (The shorter of the two
spacers should be installed on the side closer to the door of
the Jeep and the longer of the two spacers should be installed
on the side closest to the front bumper of the Jeep.)
STEP 11
Re-install the rest of the nerf bar and fasten it in
place using the 10mm nuts and 13mm bolts that
were previously removed from the Jeep. It is
best not to completely tighten down any of the
hardware until the install is completed.
STEP 12
Once all of the bolts are started in their
corresponding holes, tighten down all hardware.
STEP 13
Lastly, reinstall bolts mounting the nerf bar to the
floor boards of the Jeep.
STEP 1o
Slide the studs on the back
of the nerf bar through the
side mount and then through
the pinch seam (where it was
previously installed). The
side mount should now be
between the nerf bar and the
pinch seam on the Jeep.
STEP 7
Line up the holes in the top
of the mount with the holes
in the windshield bracket.
* Images after STEP 5 are shown without the tray attached for attachment details.
