574.293.1581 • MORryde.com
574.293.1581 • www.MORryde.com
WARNING
Improper installation may cause property damage or personal injury. The Installer assumes
all responsibility of verifying the safety and viability of any installation method and mounting surface. MORryde is
not liable for property damage or injury caused by incorrect mounting, installation methods not recommended by
MORryde, hardware not provided by MORryde, or incorrect use during travel or otherwise.
If
you
have
any
questions,
please
give
us
a
call
at
574-293-1581 or
send
an
email
to
[email protected].
TO RELEASE THE STEPS:
Press in the paddle latches and pull back to remove the step from the mounting brackets.
INSTALLATION INSTRUCTIONS
STEP 1
Line up the first bracket
with the outside edge
of the door. Verify the
placement of the bracket
by properly positioning
the steps; also confirm
clearance of the door. If
satisfactory, install the first
mounting bracket using
the supplied hardware.
STEP 2
Press in the paddle latch and
attach the step to the bar on the
bracket that was first installed;
you will use this as a guide for the
location of the second bracket.
With the steps in position, mount
the second bracket. Paddle
latch
Outside
edge of
door
Bracket
TOOLS REQUIRED: 3/8 drive socket
Please take a moment to review the Quick Connect Step Pre-Installation Instructions on the front side of this form before
proceeding with these Installation Instructions.
NOTE: The two brackets are identical. For proper installation,
mount both brackets with the bar oset to the left.
Both brackets will be mounted with the bar oset to the left.
Bar
