TRD0197-3
INSTALLATION INSTRUCTIONS:
The DDuurraaCClliippis a “lock and release” device designed to secure the drop hooks from a
wheelchair (drop-base) cushion onto the wheelchair seat frame/tube. By engaging the
plunger lock mechanism, the sliding bolt holds the drop hook (seat) in place; By
retracting the plunger lock, the seat can be easily removed for wheelchair transportation.
DURACLIP
adapter sleeve
sliding bolt
plunger lock
Standard Application (using two DuraClips):
11..Position the wheelchair seat in the desired position
on the seat frame tubes and snap the seat (drop
hooks) into place.
22..Working at the front of the wheelchair, install1a
DuraClip onto each seat tube (left & right) as illustrated in
image A.
1note: the DuraClips must be installed in front of the
drop hooks such that the sliding bolt extends rearward
over top of the drop hooks- see image C.
33..If the wheelchair uses 7/8” (22mm) diameter seat
tubes, install adapter sleeves as indicated in image B.
44..Slide each DuraClip along the seat tube until it rests
up against the drop hook. Install the mounting hardware
provided, and secure2the DuraClip in position on
the seat frame/tube-see image C.
2note: tighten hardware until clip is snug on the seat
tube- ddoonnoottoovveerr--ttiigghhtteenn!!
55..With both DuraClips installed, press down on the
plunger lock mechanism and extend the sliding bolt over top
of the drop hooks to secure the seat on the wheelchair
frame. (Ensure the plunger mechanism is lloocckkeeddinto position).
66..To unlock/release the seat from the wheelchair, depress
the plunger mechanism and retract the sliding bolt on
each DuraClip. Remove seat (drop base) cushion.
ssnnaappDDuurraaCClliipp
oonnttoosseeaattttuubbee
ffoorr77//88””((2222mmmm))ttuubbiinngg,,sslliiddeetthhee
DDuurraaCClliippoovveerraaddaapptteerrsslleeeevvee
hardware not shown
sslliiddiinnggbboolltt
ddrroopphhooookk
((rriigghhttffrroonntt))sseeaattttuubbee
front of
wheelchair
A.
B.
C.
mmoouunnttiinngghhaarrddwwaarree
