MotionComposites Tension Adjustable Backrest User manual

ASSEMBLY INSTRUCTIONS
TENSION ADJUSTABLE BACKREST
STEP 1 AFTER CONNECTING THE TUBULAR BACKREST FRAME, YOU CAN INSTALL THE
ADJUSTABLE TENSION BACKREST.
INSTALL THE STRAPS

ASSEMBLY INSTRUCTIONS TENSION ADJUSTABLE BACKREST
STEP 2 FOR THIS STEP, FOUR (4) STRAPS ARE REQUIRED.
STEP 3 HOLD THE FIRST STRAP ENSURING THAT THE VELCRO SIDE IS FACING OUT. INSERT THE STRAP
INTO THE D-RING, AS SHOWN BELOW.
STEP 4 THE STRAP SHOULD LOOK LIKE THE BELOW IMAGE.
REPEAT THIS PROCESS WITH THE THREE (3) OTHER STRAPS.

ASSEMBLY INSTRUCTIONS TENSION ADJUSTABLE BACKREST
STEP 5 INSERT THE FOUR (4) STRAPS ONTO THE LEFT TUBULAR BACKREST FRAME ENSURING THAT
THE VELCRO IS FACING YOU.
ONCE THE FOUR (4) STRAPS ARE INSTALLED, YOU SHOULD HAVE THE FOLLOWING RESULT.
STEP 6 ADJUST THE STRAP WITH LARGE ENDS TO THE PROPER LENGTH TO FIT THE TOP OF
THE TUBULAR BACKREST FRAME.

ASSEMBLY INSTRUCTIONS TENSION ADJUSTABLE BACKREST
STEP 7 SLIDE THE LEFT END ONTO THE TOP OF TUBULAR BACKREST FRAME, ENSURING THAT THE D-RINGS
ARE FACING UP. REPEAT THIS STEP FOR THE RIGHT SIDE
STEP 8 AT THIS POINT, ALL FOUR (4) STRAPS SHOULD BE INSTALLED ON THE LEFT TUBULAR BACKREST
FRAME AS WELL AS THE LARGE END STRAP, AS SHOWN IN THE BELOW IMAGE.

ASSEMBLY INSTRUCTIONS TENSION ADJUSTABLE BACKREST
INSTALL THE PUSH HANDLES
STEP 1 REMOVE THE TOP SCREWS ON THE PUSH HANDLES.
STEP 2 SLIDE THE STRAP WITH LARGE ENDS UP SO THAT YOU CAN SCREW THE PUSH HANDLE TO THE
STRAP. REPEAT THIS STEP FOR THE OTHER SIDE.

ASSEMBLY INSTRUCTIONS TENSION ADJUSTABLE BACKREST
INSTALL THE BACKREST COVER
STEP 1 LIFT THE FLAP AS SHOWN IN THE BELOW IMAGE. YOU WILL NOTICE THAT THERE IS VELCRO ON
BOTH SIDES OF THE UPPER SECTION.

ASSEMBLY INSTRUCTIONS TENSION ADJUSTABLE BACKREST
STEP 2 INSTALL THE BACKREST ENSURING THAT THE VELCRO AREA IS EVEN WITH THE VELCRO FASTENED
TO THE TUBULAR FRAME, AS SHOWN IN THE BELOW IMAGE.
STEP 3 INSERT THE FOUR (4) STRAPS INTO THE LOOPS ON THE COVER.

ASSEMBLY INSTRUCTIONS TENSION ADJUSTABLE BACKREST
THEY MUST BE INSTALLED EXACTLY AS SHOWN BELOW.
STEP 4 TIGHTEN THE STRAPS.

ASSEMBLY INSTRUCTIONS TENSION ADJUSTABLE BACKREST
STEP 5 ALL THAT IS LEFT TO DO IS TO FOLD THE PANEL BACK.