Motorola DS4800 Series User manual

DS4800 SERIES CORDED
DIGITAL IMAGER
QUICK START GUIDE

2 DS4800 Series Imager Quick Start Guide
© 2014 MOTOROLA SOLUTIONS, Inc. All rights reserved.
Motorola reserves the right to make changes to any product to improve reliability, function, or design.
Motorola does not assume any product liability arising out of, or in connection with, the application or use of
any product, circuit, or application described herein. No license is granted, either expressly or by implication,
estoppel, or otherwise under any patent right or patent, covering or relating to any combination, system,
apparatus, machine, material, method, or process in which Motorola products might be used. An implied
license exists only for equipment, circuits, and subsystems contained in Motorola products.
Warranty
For the complete Motorola Solutions hardware product warranty statement, go to:
http://www.motorola.com/enterprisemobility/warranty.
For Australia Only
This warranty is given by Motorola Solutions Australia Pty Limited (ABN16 004 742 312) of Tally Ho Business
Park,10 Wesley Court. Burwood East, Victoria. Our goods come with guarantees that cannot be excluded
under the Australia Consumer Law. You are entitled to a replacement or refund for a major failure and
compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods
repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major
failure. Motorola Solutions Australia’s limited warranty above is in addition to any rights and remedies you may
have under the Australian Consumer Law.
If you have any queries, please call Motorola Solutions Australia at 1800457 439. You may also visit our
website: http://www.motorola.com/Business/XA-EN/Pages/Contact_Us for the most updated warranty terms

DS4800 Series Imager Quick Start Guide 3
Imager Features Presentation Mode
Connect Host Interface
Set Defaults Bar Code
Set Factory Defaults
LED Indicator
Capacitive Touch Trigger
Interface Cable
Customizable Bezel
Speaker

4 DS4800 Series Imager Quick Start Guide
Enter Key Bar Code (Carriage Return/Line Feed)
Add an Enter key after scanned data.
Enter Key (Carriage Return/Line Feed)
Tab Key Bar Code
Add a Tab key after scanned data.
Tab Key
Set Up Interface (Scan Host Bar Codes)
USB Device Type
The imager defaults to the HID keyboard interface type. If the default (*) does not meet your requirements,
scan another host bar code below.
* USB Keyboard HID
IBM Table-Top USB
IBM Hand-Held USB

DS4800 Series Imager Quick Start Guide 5
USB Caps Lock Override
IBM OPOS
(IBM Hand-Held USB with Full Scan Disable)
Simple COM Port Emulation
USB CDC Host
SSI over USB CDC
Symbol Native API (SNAPI) with Imaging Interface
Symbol Native API (SNAPI) without Imaging Interface
Toshiba TEC Host
Override Caps Lock Key (Enable)
*Do Not Override Caps Lock Key (Disable)

6 DS4800 Series Imager Quick Start Guide
Emulate Keypad
Emulate Keypad with Leading Zero
Quick Keypad Emulation
Applies only when Emulate Keypad is enabled.
*Enable Keypad Emulation
Disable Keypad Emulation
*Enable Keypad Emulation with Leading Zero
Disable Keypad Emulation with Leading Zero
*Enable Quick Keypad Emulation
Disable Quick Keypad Emulation

DS4800 Series Imager Quick Start Guide 7
Scanning
Correct and Incorrect Triggering
Hand-Held Triggered and Hand-Held Presentation Scanning
Hands-Free Scanning and Aiming
012345

8 DS4800 Series Imager Quick Start Guide
User Experience
User Indications (By Default)
Decode Feedback
Scan ONE bar code for each option if the default (*) does not meet your requirements.
Tone/Beep
Indication Speaker
Sequence Indicator LED Haptic/ Vibration
Power up Power up tone Green, then fades out Double-vibrate
Ready to scan (hand-held mode) None None None
Ready to scan
(hands-free/presentation mode)
None Pulsing green None
Trigger touch None None Vibrate for 100 ms
Bar code decoded Wood block /
scan tone 1
Green for 100 ms None
Transmission error detected; data
is ignored
4 long low tones Red None
Successful parameter setting High/low/high/low tone Green for 1 second None
Incorrect parameter, programming
sequence, or Cancel bar code
scanned
Low/high tone Red for 2 seconds None
*Enable
Disable

DS4800 Series Imager Quick Start Guide 9
Haptic/Vibration
Indicator LED
Trigger Feedback
Scan ONE bar code for each option if the default (*) does not meet your requirements.
Trigger Audio Click
Haptic/Vibration
Enable
*Disable
*Enable
Disable
Enable
*Disable
*Enable
Disable

10 DS4800 Series Imager Quick Start Guide
Scan Tone
Scan ONE bar code for each option if the default (*) does not meet your requirements.
123Scan2
123Scan2is an easy-to-use, PC-based software tool that enables rapid and easy customized setup of a
scanner via a bar code or USB cable. For more information, visit: http://www.motorolasolutions.com/123Scan.
Utility Functionality
• Device configuration
•Electronic programming (USB cable)
•Programming bar code(s)
• Data view – Scan log (display scanned bar code data)
• Access asset tracking information
• Upgrade firmware and view release notes
• Remote management (SMS package generation)
*Wood Block / Tone 1
Pulse / Tone 2
Chime / Tone 3
Zap / Tone 4
Triple Beep / Tone 5