MSA ALTAIR5 User manual

ALTAIR5/5X Multigas Detector Quick Start Card
Please review the back of this card for a detailed illustration of the following
components:
TButton SButton Button
•Charge battery until green LED is lit (rechargeable units only).
•Turn the instrument ON with the button. Instrument performs a
self test and sensor warm up, then displays sensor info and set points.
•A flow test must be performed during startup. Block pump inlet when
instructed.
•Fresh Air Setup: press buttons corresponding with 'YES' or 'NO' on the
display.
•To page through the screens, use the Tbutton from the
Normal Operation screen, follow display instructions and press
corresponding buttons to advance to next page.
•To reset alarms press Sbutton.
•Perform a Bump Test/Calibration Check daily for each installed sensor.
•To calibrate: ensure you are in fresh air and press and hold the Sbutton
and follow instructions on the screen. See operating manual for
complete calibration instructions.
•To activate/deactivate MotionAlert feature, use the Tbutton until
MotionAlert screen and follow display instructions.
•To activate InstantAlert, press and hold Tbutton.
•Turn the instrument OFF by holding the button.
WARNING
This quick start card provides only a brief description of the operating
instructions for the ALTAIR 5/ALTAIR 5X Multigas Detector. The user of
this instrument must be fully aware of the limitations and instructions
supplied in the operating instruction manual. Failure to follow the
instructions may lead to serious personal injury or death.
10100750/01
GB

ALTAIR5/5X Multigas Detector Quick Start Card
1
3
2
10100750/01
GB