MSI M98 User manual

CONTENTS
• MSI Bluetooth Mouse
• USB dongle
• User manual
• BLE Compatibility
Windows8, 10 or later
Mac OSX 10.5 or later
Android 4.3 or later
SYSTEM REQUIREMENTS
INSTALLING HARDWARE
LED Indicator on Mouse:
Status Description
Pairing Flashing
(3-8 seconds)
To indicate the
pairing process
when the mouse
is ON
MOUSE
TROUBLE SHOOTING GUIDE
Malfunctions may be caused by reasons such as a dead battery, incorrect battery installation, or an unsuccessful pairing.
Try the following troubleshooting methods:
• Check that the ON/OFF switch at the bottom of mouse is set to ON.
• Check that the batteries are installed in the correct orientation(+/-).
• Restart your Laptop and re-pair your mouse as per instructions above.
• Switch your mouse to OFF and back to ON. The LED status lights should illuminate briefly
- if they do not, please change batteries.
• Is the USB dongle securely plugged into a USB port? Try moving the dongle to a port closer to the mouse.
• Remove any metal objects between the USB dongle and the mouse that may interfere with reception.
• Try using the mouse on a different surface.
General Installation:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
2.4GHz Mode:
(White LED is in 2.4GHz mode)
Step 1: Remove the back cover and insert two AAA batteries.
Step 2:Remove the USB dongle from the mouse and plug directly
into your notebook’s USB port.
Step 3: Switch the mouse’s ON/OFF button to ON.
The mouse will automatically connect to the Laptop.
2.4GHz Mode connection repair
(White LED is in 2.4GHz mode)
If the mouse experiences connection issues, follow this simple procedure:
Step 1: Switch the mouse’s ON/OFF switch to ON.
Step 2: Hold the Mode Switch Button until white LED flashes
Step 3: Plug the dongle into the notebook USB port, the LED indicator will be off once pair is successful.
Bluetooth Mode:
(Blue LED is in Bluetooth mode)
Step 1: Remove the back cover and insert two AAA batteries.
Step 2: Switch the mouse’s ON/OFF button to ON.
Press mode switch button and blue LED indicator, it means Bluetooth mode.
Step 3: Then hold the mode switch button until blue LED flashes,
then search for “MSI Bluetooth Mouse” in your notebook and connect to pair.
The LED indicator will be off once pair is successful.
Sleep Mode:
The mouse will enter sleep mode when unused for 8 minutes.
Move the mouse to end sleep mode.
DPI: Adjustment (Default 2000):
Press the middle & left buttons simultaneously to adjust DPI (1000 / 1500 / 2000).
• 2.4G Compatibility
Windows7, 8, 10 or later
Mac OSX 10.5 or later
无线蓝牙鼠标 / 無線藍芽滑鼠
MSI Bluetooth Mouse
Mode Switch Button
（BLE / 2.4GHz）
Model:M98
Product Name: MSI Bluetooth Mouse
FCC ID: 2ABVN-M98
IC: 24513-M98
Rating: DC 3V 6mA
Operating Temperature:-25~55℃
Radio Frequency: Bluetooth
Frequency Band: 2402 MHz-2480 MHz
Max. RF Power: 1.93 dBm
Radio Frequency: 2.4GHz SRD
Frequency Band: 2402 MHz-2480 MHz
Max. RF Power: -2.18 dBm
Model:M98D
Product Name:2.4G Wireless Dongle
Radio Frequency: 2.4GHz SRD
Frequency Band: 2405 MHz-2470 MHz
Max. RF Power: -23.51 dBm

商品名称及型号: 无线蓝牙鼠标/M98
功能规格或相容性/使用方法/警语/注意事项…等详细资料请参阅产品包装说明
委制商: 微星科技股份有限公司 制造国别: 中国
制造年份/序号: 2020/生产序号请参阅产品包装贴纸
地址: 新北市中和区立德街69号 电话: [phone]
商品名稱及型號: 無線藍芽滑鼠/M98
功能規格或相容性/使用方法/警語/注意事項…等詳細資料請參閱產品包裝說明
委製商: 微星科技股份有限公司 製造國別: 中國
製造年份/序號: 2020/生產序號請參閱產品包裝貼紙
地址: 新北市中和區立德街69號 電話: [phone]
无线蓝牙鼠标 / 無線藍芽滑鼠
MSI Bluetooth Mouse
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment and it also complies with
Part 15 of the FCC RF Rules. This equipment must not be co-located or operating in conjunction with any other antenna or
transmitter. End-users and installers must be provide with antenna installation instructions and consider removing the
no-collocation statement.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
Caution!
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
Canada Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes :
1) L’appareil ne doit pas produire de brouillage;
2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement.
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102 RF
exposure, users can obtain Canadian information on RF exposure and compliance.
Le dispositif rencontre l'exemption des limites courantes d'évaluation dans la section 2.5 de RSS 102 et la conformité à
l'exposition de RSS-102 rf, utilisateurs peut obtenir l'information canadienne sur l'exposition et la conformité de rf.
Hereby, Verico International Co., Ltd declares that the radio equipment type MSI Bluetooth Mouse is in compliance with
Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address:
www.msi.com
CE

WEEE STATEMENT
CHEMICAL SUBSTANCES INFORMATION
RoHS STATEMENT
Japan JIS C 0950 Material Declaration
INDIA RoHS
TURKEY EEE REGULATION
Conforms to the EEE Regulations of the Republic Of Turkey.
UKRAINE RESTRICTION OF HAZARDOUS SUBSTANCES
VIETNAM RoHS
TAIWAN RoHS CHINA RoHS
European Union: Under the European Union ("EU") Directive on Waste Electrical and Electronic Equipment,
Directive 2002/96/EC, which takes effect on August 13, 2005, products of "electrical and electronic equipment"
cannot be discarded as municipal waste anymore and manufacturers of covered electronic equipment will be
obligated to take back such products at the end of their useful life.
In compliance with chemical substances regulations, such as the EU REACH Regulation (Regulation EC No. 1907/2006 of the
European Parliament and the Council), MSI provides the information of chemical substances in products at:http://ww-
w.msi.com/html/popup/csr/evmtprtt_pcm.html
A Japanese regulatory requirement, defined by specification JIS C 0950, mandates that manufacturers provide material
declarations for certain categories of electronic products offered for sale after July 1, 2006.
http://www.msi.com/html/popup/csr/cemm_jp.html
http://tw.msi.com/html/popup/csr_tw/cemm_jp.html
This product complies with the "India E-waste (Management and Handling) Rule 2011" and prohibits use of lead, mercury,
hexavalent chromium, polybrominated biphenyls or polybrominated diphenyl ethers in concentrations exceeding 0.1 weight %
and 0.01 weight % for cadmium, except for the exemptions set in Schedule 2 of the Rule.
The equipment complies with requirements of the Technical Regulation, approved by the Resolution of Cabinet of Ministry of
Ukraine as of December 3, 2008 № 1057,intermsof restrictions for the use of certain dangerous substances in electrical and
electronic equipment.
As from December 1, 2012, all products manufactured by MSI comply with Circular 30/2011/TT-BCT temporarily regulating
the permitted limits for a number of hazardous substances in electronic and electric products.
單元 Ｕnit
限用物質及
其
化學符號
鉛 Lead
(Pb)
汞 Mercury
(Hg)
鎘 Cadmium
(Cd)
六價鉻
Hexavalent
chromium
(Cr
+6
)
多溴聯苯
Polybrominated
b i phe n y l s
(PBB)
多溴二苯醚
Polybrominated
diphenyl ethers
(PBDE)
電路板總成 -○ ○ ○ ○ ○
金屬機構件 - ○ ○ ○
塑膠機構件 ○ ○ ○ ○ ○ ○
其它 - ○ ○ ○ ○ ○
備考1.〝超出0.1 wt % 〞及〝超出 0.01 wt %〞係指限用物質之百分比含量超出百分比含量基準值。
備考2.〝○〞係指該項限用物質之百分比含量未超出百分比含量基準值。
備考3.〝－〞係指該項限用物質為排除項目。
Restricted substances and its chemical symbols
Note 1：“E
xceeding 0.1 wt %” and “exceeding 0.01 wt %” indicate that the p
ercentage content of the restricted substance
exceeds the
reference percentage value of presence condition.
Note2：“○
” indicates that the percentage content of the restricted substance
doesnot exceed the percentage of reference value of presence.
Note3：The “−” indicates that the restricted substance corresponds to the exemption.
○ ○
限用物質含有情況標示聲明書
产 品 中有 害 物质 的 名 称及 含 量
部 件 名称
有 害 物质
铅
( )Pb
汞
( )Hg
镉
( )Cd
六 价铬
( CrVI) ( )PB B
多溴 二苯 醚
( )P BD E
印 刷电 路板 组件 ×
金属 部件
其它
塑胶 部件
多溴 联苯
○
○
○×
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
本 表格 依据 的规定 编制 。SJ/T 1 1364
○ ： 表示 该有害 物质 在该 部件 所有 均质材 料中 的含 量均 在 规 定的 限量GB/T 2 65 72
要 求以 下。
×：表 示该 有害 物质至 少在 该部 件的 某一均 质材 料中 的含 量超出 规 定GB/T 2 6 5 72
RoH S的 限量 要求 ，但 所有部 件都 符合 欧盟 要求 。
* 印 刷 电路板 组件: 包 括 印刷 电路板 及其 构成 的零 部件。
■ 上 述有 毒有害 物质 或元 素清 单会依 型号 之部 件差 异而有 所增 减。
■ 产 品部 件本体 上如 有环 保使 用期限 标识 ，以 本体 标识为 主。
○
×
无线蓝牙鼠标 / 無線藍芽滑鼠
MSI Bluetooth Mouse