Instructions for use: Top rack dishwasher safe.
Safe for all ages.
Cleaning and Maintenance: Carefully
disassemble the LATCH™Transition Cup. Wash
all components with soap and hot water and
rinse thoroughly. Use LATCH™Deluxe Bottle
Brush for best results. All cup parts are top rack
dishwasher safe. For best results, use Munchkin®
High Capacity Dishwasher Basket (available at
munchkin.com) to secure spout, valve and collar
during wash and dry cycles.
Assembly: Before each use, hold the tip of the
valve (triangular head) up to the light to see the
slit and pinch apart to ensure proper venting.
When assembling your LATCH™Transition Cup,
first push the valve firmly through the hole at the
bottom of the Transition Cup. Make sure that
the triangular head of the
valve is fully inserted. A fully
inserted valve will have a
visible gap between the
bottom edge of the
triangular head and the hole
opening at the bottom of
the Transition Cup. You may not always see a
gap unless you apply upward pressure with your
thumb, as you inspect. (see Figure 1)
Pull the spout through the collar of your LATCH™
Transition Cup, making sure it is pulled all the
way to the locked position. The locked position
is when the base of the spout is flush against the
upper rim of the collar (no gap). It is easier to
assemble if you pull the spout back and forth
and upwards, instead of pulling it straight up.
Make sure the 3rd segment under the accordion
is resting above the collar. (see Figure 2)
Screw the collar onto the thread of the transition
cup in a clockwise direction to securely tighten
the collar. When assembling the cap, make sure
to place the cap vertically onto the Transition
Cup so the spout sits upright and is sealed.
CAUTION: Wash and inspect before first use.
Do not microwave or use with hot liquids. Do not boil or
sterilize. Discard and replace at first sign of damage.
Always check temperature before drinking. Do not let child
walk or run while carrying the cup. Spout is not intended to
be used as a teether. Do not allow child to bite or chew on
spout. Do not leave child unattended during use. Discard
all packaging components before giving to the child.
PRODUCT AND DESIGN ARE TM & ©2013 MUNCHKIN,
INC. MUNCHKIN, THE LATCH LOGO AND IT’S THE LITTLE
THINGS ARE TRADEMARKS OR REGISTERED TRADEMARKS
OF MUNCHKIN, INC. 7835 GLORIA AVE., VAN NUYS, CA
91406. PATENT: HTTP://WWW.MUNCHKIN.COM/PATENTS.
MADE IN CHINA.
CCD-0115-001 REV1
4oz /118ml
Transition Cup
Instructions
Figure 1
Visible gap
with valve
inserted
Figure 2
Cap Spout
Collar
Cup
Handles Valve
See how it works at
latchbottles.com
FRONT
BACK
