MyCharge 6000 User manual

Owner’s Manual
Portable Power
Bank 6000
™

2
Thanks for choosing myCharge.
In The Box
• myCharge Portable Power Bank 6000
• USB to Micro-USB Charging Cable
• Owner’s Manual

3
USB
Output
Micro-USB Apple 30-pin
Mini-USB

4
Quick Start
1. Unfold the appropriate built-in connector from its storage position and
connect it to the device you want to charge. You can also supply your own USB device
cable and connect it to the full-size USB port.
2. Move the function switch left into the on/charge position (green indicator) to begin charging. (Fig. 1)
3. When nished, move the function switch back into the off/sync position (red indicator) to
prevent unnecessary discharging.
Fig. 1
Level Check ButtonMicro USB Input
Function Switch
LED Indicators

5
Charging Power Bank
Please fully charge your Power Bank before using the rst time.
To charge, connect the included USB cable’s Micro-USB connector
to Power Bank’s charging port (Fig. 2) and the other end to the USB
wall adapter that came with the device you want to charge or a
computer. When connected, the LEDs on the side of the unit will
ash indicating that it is charging. Charge time for Power Bank
alone is about 3.5 hours from a standard 2.1A iPad® USB
wall adapter, or about 6.5 hours from a standard 1A iPod®/
iPhone® USB wall adapter. Note: USB wall adapters not included. Note: It is
normal for Power Bank to be warm to the touch while in use.
Fig. 2

6
Powering On and Off
To keep your Power Bank fully powered and ready to charge, keep the
function switch (Fig. 1) in the off/sync position when not in use. This deactivates all
connectors as well as the level check button so there is no unintentional drain on the battery. To
turn your Power Bank on, move the function switch left into the on/charge position (green indicator).
All connectors can now charge devices, and the level check button will report the current status.
Note: It is normal for Power Bank to be warm to the touch while in use.
Charging Devices
A Micro-USB, Mini-USB and Apple® connector are built-in to let you charge hundreds
of devices without the need for any additional adapters, as well as a full
size USB port for charging almost anything else.

7
To charge a device, connect it to the appropriate connector and move the
move the function switch left into the on/charge position (green indicator). To charge a device
with your own USB cable, connect the cable to your device and insert the USB connector into
Power Bank's full-size USB port. Power Bank is capable of charging up to 4 devices at the same time.
When Power Bank's internal battery is depleted beyond the ability to charge the connected devices, all
LEDs will ash for 30 seconds indicating it's time to connect a power source. Use a standard USB iPad
or iPod/iPhone wall adapter, or one that came with your device rated for 1A output or more. The
charge time of your Power Bank with devices attached will vary depending on the current
charge level of those devices and its internal battery.

8
Overload Protection
Power Bank enables you to charge multiple devices. Because devices
vary in their power requirements, it's possible to connect a group of devices that need
more than what Power Bank can supply. When this occurs, Power Bank implements overload
protection. LEDs will ash indicating which device cannot be charged because its power needs are
too great:
• Left 2 LEDs ash - A device connected to the Micro or Mini USB connector
• Middle 2 LEDs ash - A device connected to the USB port with your cable
• Right 2 LEDs ash - A device connected to the Apple connector

9
In the event of an overload, unplug the last device connected. To
manually reset, disconnect all devices, move the function switch to the off/sync position
and then back to on/charge before reconnecting devices in the priority order you prefer.
Syncing
Your iPod, iPhone or iPad can be synced to a computer while connected to Power Bank. Simply
connect Power Bank to your computer with the provided USB cable, move the function switch
to the off/sync position (right) and connect your device to the Apple connector. Note: Power
Bank does not support sync through the built-in Micro-USB or Mini-USB connectors.

10
Battery Indication
To check how much battery is left, make sure the function switch is in
the on/charge position (green indicator) and press the level check button on Power
Bank’s side. (Fig. 1).
• LED 1 is lit - 00-17% Power
• LED 2 is lit - 17-34% Power
• LED 3 is lit - 34-50% Power
• LED 4 is lit - 50-67% Power
• LED 5 is lit - 67-84% Power
• LED 6 is lit - 84-100% Power

11
Hours Chart
*Average smartphone statistics are based on a 1400mAh battery.
Talk Standby Browsing Video Audio/Music
iPhone 4 +24hrs
(3G)
+1029hrs +34hrs (Wi)
+21hrs (3G)
+34hrs +137hrs
iPad +7hrs +7hrs +7hrs
iPod touch +35hrs +202hrs
Average
Smartphone*
+24hrs +1029hrs +34hrs (Wi)
+21hrs (3G)
+34hrs +137hrs

12
Maintenance
To keep your Power Bank operating at its full potential, please do the following:
1. Re-charge every three months when not in use.
2. Keep dry and away from moist and corrosive materials.
3. Do not immerse in water, air dry. To clean, wipe surface with damp cloth.
Product Specifications
Battery: 6000mAh Lithium Polymer
Input: 5VDC, 1.8A
Apple Connector Output: 5VDC, 2.1A
Mini-USB/Micro-USB Output: 5VDC, 1A combined
USB Output: 5VDC, 1A

13
Troubleshooting
• My device is not charging or (The status indicator lights
are not glowing): Conrm that your device is properly connected to the appropriate
connector on Power Bank. Make sure the function switch for Power Bank is in the on/charge
position (left with green indicator). Press the level check button to verify that Power Bank's battery
has a charge. If no status is shown, please connect Power Bank to a power source with the included
USB cable.
• My device is not charging and Power Bank's LEDs are flashing in pairs: Power
Bank is in overload protection. Unplug the last device connected, noting that it may take some
time for the lights to stop ashing. To manually reset, disconnect all devices, move
the function switch to off/sync and then back to on/charge before
reconnecting devices. If the overload

14
occurs again, you may have a combination of
devices that require too much power to connect simultaneously.
• My device is not charging and all Power Bank's LEDs are flashing: Your
Power Bank is out of power. Connect the included USB cable to Power Bank and the other end
to a power source.
• My Apple device is not syncing: Conrm that your device is properly connected to the Apple
connector. Conrm that the Power Bank is properly connected to your computer with the included
USB cable. Make sure that the function switch is in the off/sync position (right with red indicator).
For additional troubleshooting tips, please visit us at
www.mychargepower.com

15
Warnings
Read all instructions and warnings prior to using this product. Improper
use of this product may result in product damage, excess heat, toxic fumes, re or
explosion, for which myCharge is not responsible. (1) Do not store battery in high temperature
environment, including intense sunlight or heat. Do not place battery in re or other excessively hot
environments. (2) Be cautious of excessive drops, bumps, abrasions or other impacts to this battery.
If there is any damage to the battery such as dents, punctures, tears, deformities or corrosion, due to
any cause, discontinue use and contact the manufacturer or dispose of it in an appropriate manner.
(3) Do not disassemble the battery or attempt to repair or modify it in any manner. (4) Do not
expose this battery to moisture or submerge it in liquid. Keep battery dry at all times. (5)
Do not attempt to charge battery using any other method, apparatus, or
connections other than the device’s USB connector.

16
For directions on the various ways to charge your
myCharge product please refer to the owner’s manual. (6) Do not attempt
to replace any part of the battery. (7) If this battery is intended by the Purchaser to be
used by a minor, purchasing adult agrees to provide detailed instructions and warnings to any
minor prior to use. Failure to do so is the sole responsibility of the purchaser, who agrees to indemnify
the Manufacturer for any unintended use or misuse by a minor. (8) All batteries have gone through a
thorough quality assurance inspection. If you nd that your battery is excessively hot, deformed, cut,
emitting odor, experiencing or demonstrating an abnormal phenomenon, immediately stop all battery
use and contact the manufacturer. (9) For extended storage, rst charge your battery for one hour.
(10) Never dispose of batteries in the garbage. This is unlawful under state and federal
environmental laws and regulations. Always take used batteries to your
local battery-recycling center.

17
Note: The Manufacturer is not responsible
for any damages one may suffer as a result of use, intended or
unintended, or misuse of this battery in conjunction with any device or accessory
other than the appropriate entertainment device for which this battery is designed.
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.

18
Note: The manufacturer is not responsible
for any radio or TV interference caused by unauthorized modications
to this equipment. Such modications could void the user authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.

19
However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

20
ONE YEAR LIMITED WARRANTY
RFA Brands sells its products with the intent that they are free of
defects in manufacture and workmanship for one year from the date of original
purchase, except as noted below. RFA Brands warrants that its products will be free of defects
in material and workmanship under normal use and service. This warranty extends only to
consumers and does not extend to Retailers.