Mytee Dry GT User manual

1ADM-8400GT | REV. 12/07/2021
User Manual
2 - Setup
Choose between the included
blue and black comfort grips.
Clean the indentation area
on the tool thoroughly with
alcohol. Peel o the adhesive
backing and stick the grip onto
the tool within the indentation.
The vacuum hose can be connected directly to an extractor.
If a longer hose length is necessary, connect to another hose
using the included barb-to-barb tting. Connect the male
quick connect tting from the solution line to the female
solution quick connect tting either on the extractor or a
longer solution hose.
3 - Using the Mytee Dry GT in the
Field
1. After the Mytee Dry GT is connected to your extractor, turn
on the extractor’s vacuum(s) and then the solution pump (if
they’re on separate switches).
2. Make sure the ball valve
at the end of the solution
hose is turned parallel to
the hose, allowing solution
to ow through.
3. Dial in the desired amount
of solution ow using the
ow control knob. The
amount of solution ow
needed will depend on the
material, its absorbency,
and how soiled it is. Turn
the knob counterclock-
wise to restrict ow and
clockwise for higher ow.
4. Use the vacuum release
dial to relieve some
suction if necessary. In
general, you’ll want to
relieve more vacuum the
more delicate the material
is. Just twist the dial to
reveal the vacuum release holes.
5. Begin cleaning by moving the cleaning head of the tool
back and forth on the upholstery material.
4 - Maintenance
Maintenance Action Frequency
Rinse out any left over
chemicals or dirt residue by
running clean water through
the tool.
After each use.
Check spray bar for any
clogged orices. If there’s a
clog, clear the obstruction
with a small needle.
After each use.
Congratulations on the purchase of your new Mytee Dry GT Upholstery Tool! With proper care and maintenance, we believe this
tool will be a valuable part of your cleaning arsenal for years to come.
Please note that neglect, abuse, or improper use of this tool will void the warranty. Before using this tool, please read and
understand this manual thoroughly.
Brass ttings can be extremely hot during and
after use. Tightly wrap the included Heatguard
Hose Wrap around exposed ttings to
prevent burns.
1 - Package Contents
Heatguard™ Hose
Wrap
1.5” vinyl slip cu
1.5” barb-to-barb
coupler tting
Mytee Dry GT with
15’ x 1.25” hose
combo
One black
and one blue
comfort grip
Mytee, LLC
13655 Stowe Dr.
Poway, CA 92064
858.679.1191

2ADM-8400GT | REV. 12/07/2021
Clean the inline lter behind
the quick connect tting on
the solution hose (#21 in the
diagram below).
When there’s a noticeable
loss of solution ow.
Wipe the tool down with a
damp cloth.
As often as needed.
5 - Useful Tips
Rinsing out inside the tool.
If there’s a buildup of dirt inside the tool that can’t be removed
by running clean water through it, remove the clear window in
order to clean out the inside of the tool. When done, re-attach
the window.
Cutting o solution ow.
Fine-tuning of the solution ow can be done with the ow
control knob on top of the tool. You can also completely shut
o ow by turning the same knob all the way clockwise.
Switching between hose cus.
To remove a hose cu from the hose, twist the cu clockwise
until it comes o. Twist a new cu all the way on using a
counter clockwise motion.