Streamline Filterplus MOBI SK User manual

INSTRUCTION
MANUAL
Packed By
Checked By
Date Checked
CODES
FT072-294-022
MOBI® SK KIT
THE KIT INCLUDES
1 x MOBI™ Filter
1 x 34ft Glass Fibre Pole
10mtr ECOLINE™ Hose Tubing
1 x Hi-Lo 14inch brush
2 x Fan Jets
1 x Anti-snag Aluminium Coupler
Hose Kits
1 x Handheld TDS Meter
*Image for illustrative purposes only and may not
represent the specific kit.

Thank you for purchasing a STREAMLINE®
MOBI™ STARTER KIT
The STREAMLINE® MOBI® starter kit is designed for, simple but
eective, cleaning of windows, facades and other flat surfaces. The
deionising filter removes all contaminants from the water and ensures
a clean and streak-free finish. The kit can be connected to any mains
water source, and uses the water pressure to pressurise the system.
When cleaning windows, remember to pay special attention to the frames, especially if it is the
first time this method of window cleaning is being used. The most important part of the cleaning
process is the rinsing, after the window has been cleaned. To do this, lift the brush away from the
glass and move the head from side to side working from top to bottom, allowing the water to
create a sheet, therefore rinsing the glass. Extra care must be taken if the water refuses to ‘sheet’,
as this makes rinsing successfully more dicult. If you are cleaning windows on a warm day, the
rinsing procedure must be done meticulously, as warm, direct sunlight can cause spotting, due to
insucient rinsing.
ONE YEAR
WARRANTY
SETTING UP
• If the brush assembly has removable
spray jets, insert these jets into the
desired positions in the brush, and turn
them through 90 degrees to secure the
spray jets in place.
• Screw the brush assembly onto the end
of the telescopic pole.
• Connect the thin red hose to the
T-connector on the brush assembly.
This hose runs down the centre of the
telescopic pole and out the bottom,
terminating in a hose connector.
• Attach the hose connector to the outlet
fitting of the deionising filter.
• Attach the black, connecting hose to
the inlet of the deionising filter and the
other end to a mains water supply.
• Turn on the tap at the mains water
supply and regulate the water flow until
a desired pressure is achieved out of
the spray jets.
• Test the water quality, measured in
parts per million (PPM), by capturing a
sample of water in the cap of the TDS
meter. Switch the TDS meter on and
dip and hold the tip of the meter in the
water sample. The water TDS should
read 000 PPM for an eective clean.
INSTRUCTIONS FOR USE

INSTRUCTION MANUAL
SERVICE
The life of the deionising filter is directly
relative to the PPM of the mains water
supply. The filter will become exhausted
quicker in hard water areas than in soft
water areas. If the quality of the water
measures more than 005PPM the resin is
exhausted and must be replaced.
• Isolate the system by turning o the
mains water supply and allow the
system to depressurise completely.
• Remove the hoses from the inlet and
outlet connections.
• Unscrew the head of the filter vessel
and draw the head and riser assembly
out of the resin bed.
• Invert the housing and empty the resin
contents into a bucket or a suitable
empty container. Use tap water to flush
the resin residues out of the empty
filter housing.
• The resin is not hazardous and must be
disposed of in a responsible manner.
• Fill the housing with fresh resin, allowing
an air gap at the top of approximately 3
inches. (Part code: MB115)
• Clean the rim of the vessel and the
sealing O-ring on the underside of
the black lid and apply a thin film of
lubricant to the rubber O-ring.
• Re-introduce the riser and firmly press
it through the resin bed.
• If it doesn’t bottom, don’t force it, but
lift up the vessel and give it a shake
whilst keeping pressure on the top lid.
• Screw the head on securely.
• Re position the hose and continue with
your cleaning.

The warranty on Machines and Equipment
is for 1 year from RECORDED DATE OF
PURCHASE.
If VARITECH SYSTEMS receives notice of
such defects during the warranty period,
STREAMLINE® will either, at its opinion,
repair or replace components which prove to
be defective.
Replacement parts will only be supplied under
warranty, upon the inspection and approval of
the defective parts by STREAMLINE®.
Should it be necessary to supply replacement
parts before the opportunity to inspect, these
will be charged at current prices and credit will
only be issued upon subsequent inspection
and warranty approval by STREAMLINE®.
The customer is responsible for the cost of
return of the defective part. If warranty is
approved, STREAMLINE® will pay for the cost
of the repaired or replacement part.
REPLACEMENT PARTS SUPPLIED UNDER
WARRANTY WILL BE GUARANTEED
FOR THE REMAINDER OF THE ORIGINAL
PARTS WARRANTY AND NOT FROM THE
INSTALLATION DATE.
This warranty excludes the following conditions
and circumstances which are at the discretion
of STREAMLINE® :
WEAR AND TEAR, MISUSE, ABUSE, IMPROPER
MAINTENANCE, FROST DAMAGE, THE
USE OF CHEMICALS OTHER THAN THOSE
SUPPLIED OR APPROVED BY STREAMLINE®,
IMPROPER INSTALLATION OR REPAIR,
UNAUTHORISED MODIFICATION, INCIDENTAL
OR CONSEQUENTIAL COSTS, LOSS OR
DAMAGE, SERVICE, LABOUR OR THIRD
PARTY CHARGES, THE COST OF RETURNING
DEFECTIVE PARTS TO STREAMLINE®.
This warranty constitutes the exclusive remedy
of any purchaser of a STREAMLINE® unit
and is in lieu of all other warranties, express
or implied, including without limitation any
implied warranty of merchantability or fitness
for use, to the fullest extent permitted by
law. In no event shall any implied warranty of
merchantability or fitness for use exceed the
term of the applicable warranty stated above
and STREAMLINE® shall have no other
obligation or liability.
These rights cannot be transferred to a
third party.
Varitech Systems Hamilton House, 8 Fairfax Road,
Heathfield Industrial Estate, Newton Abbot, Devon
TQ12 6UD, UK
Call 01626 830830
Email [e-mail]
www.varitechsystems.co.uk
THIS WARRANTY EXCLUDES
NORMAL MAINTENANCE ITEMS,
including but not limited to HOSES,
FILTERS, O-RINGS, DIAPHRAGMS,
VALVES, GASKETS, CARBON
BRUSHES and damage to motors and
other components as a result of failure
to replace normal maintenance items.
THIS LIST IS NOT EXHAUSTIVE.
STREAMLINE® WARRANTY