Nabis A05034 User manual

Nabis Round / Square
Shower Arm
Instructions
Product code:
A05034 A05035
Please keep these instructions for future reference.

Water Fitting Requirements
It is important to ensure that this product is installed in accordance with current Water Regulations and good plumbing
practice.
Please note - This product is intended to be used in conjunction with other products such as a concealed shower valve.
Pipe Connections
IMPORTANT. Before making any inlet pipe connections all supplies MUST be thoroughly ushed to remove any
debris. Failure to do so could result in damage or low ow from the tting.
General Installation Notes
• Care must be taken during installation to prevent any risk of damage to the product or injury to installer.
• Installation must be carried out by a qualied and competent person and in accordance with the instructions supplied.
• Installations must comply with all Local and National Water Authority Regulations and Building/Plumbing
Regulations.
• Ensure that you have read and understood all sections of this manual before installation.

Installation
1. Before installation ush out pipes,and then turn off water supply.
2. Prepare a hole in the desired location of the shower arm.
3. Determine the length of pipe required to connect the mixer to the shower arm. To do this, t the ange and
xing nut to the shower arm, push tail end of shower arm through hole in the wall.
Note: for the square shower arm, xing nut is not supplied /required.
4. Push ange to wall until cover all joints. It is advisable to apply a small bead of silicone sealant between the
ange and the wall.
5. Place backnut washer over tail end and secure with backnut. Be sure to leave 10 mm of threaded tube to allow
plumbing connection.
6. Connect to water supply using suitable plumbing tting.
7. Turn on water supply and check for leaks.
Backnut washer
Backnut
Wall
Flange
Fixing nut
Shower arm
Backnut washer
Backnut
Flange
Shower arm
Wall

Care & Maintenance
To maintain the surface nishes, simply wipe occasionally with a mild detergent on a soft damp cloth. Dry using a soft cloth.
Never use abrasive cleaners or chemical household cleaners, and avoid contact with concentrated bleach.
Nabis products are manufactured to the highest of standards and should require little or no maintenance. In the unlikely event of
any spare part requirements, please contact our telephone helpline number.
Telephone Helpline
Should you require any technical help in association with your Nabis product please call 0344 292 7060 with your query.
Warranty: 5 Years
For detailed warranty information, please visit our website: www.nabis.co.uk
Address:
Wolseley
CV34 6DY
Website:
www.nabis.co.uk
5
WUK INST 85 Rev.1.0